October 17, 2012, 9:59 am
My handbrake release button cover (plastic bit at the tip) has been missing since I bought the car, exposing the bit of metal.
Handbrake works fine, but looks rough.
I ordered one from Ford (cost only a few quid), but wondering, is it just "stick it on at the top" job or more complicated than that?
October 17, 2012, 1:46 pm
it just pushes on you should have posted here first i have a spare in the kitchen drawer you Could have had
October 17, 2012, 1:50 pm
Aw thanks for your offer. Just ordered it as I was fed up without it. Picking it up tomorrow.
Great it's a simple fit, maybe even I'll be able to do it myself!!!!
October 17, 2012, 2:11 pm
just pop it on the end and push theres a clip top and bottom that clips into the hanbrake