Ford Owners Club - Ford Forums Messages
Ford Fair 2016: Tickets and stand passes are now available to purchase. More info here.
Review your Ford: Help others when it comes to buying a car like yours and review your Ford now
AdBlock WarningParts of this website do not function properly with AdBlock enabled on your device. To get the best user experience on our website, please disable Adblock for this website (domain) on your browser.
Thanks for your help so far - today I have had some more info through from the dealer (It is TCH in Derbyshire which is one of the largest ford dealers in the country) Fault codes P060A-68 – PCM Internal control module monitoring processor performance. Compression Test Cylinder 1 : 125 psi Cylinder 2 : 125 psi Cylinder 3 : 130 psi Cylinder 4 : 125 psi V C T Angles Inlet : 7.12 degrees Exhaust : 13.5 degrees Cylinder Leakage Test Cylinder 1 : 12 % Cylinder 2 : 15 % Cylinder 3 : 13 % Cylinder 4 : 10 % Fuel Pressure General : 4.02 bar Thanks for the help. Gareth
Hello, I am new to this forum but have been looking at your posts over the last few months. I have a 56 reg 1.6 petrol ghia. The car has developed a hesistaion while cold always at 2000 rpm is fine awat from 2000 rpm. The car is only a week out of warranty and the local garage have had the car for nearly two weeks now and they have done Car computer diagnostic - an error code that they have never seen and have no clue what it is! Temporarly swapped spark plugs, HT leads and coil pack from another car - no change Complete fuel tank and pump removal check - no problem 3 sets of compression test at different time (first they said it was OK, then not OK (140-155psi range) Cylinder leakage test! They have not found the fault but think it may be the conrods are bent (Want over £800 to take apart the engine and check - but no guarantee its the fault!). The car has never been driven in the flood and never hydrolocked. Also why would this problem be only when cold and at a certain engine speed - Surely it would be all the time? The garage cannot anwser any of my questions above which has left me really worried! Does anyone have any advice on what it could be as I am sure it is not bent conrods?! Many thanks, Gareth