• Announcements

    • Stoney871

      Posting in General Chat thread.   11/11/2017

      it has been noted that too many Members are posting messages in the General Chat area instead of the correct Forums. Any messages posted in the General Chat area that are not General Chat will be deleted without warning and offenders may recieve warning points if repeated instances are seen from that Member. There are plenty of different Club areas that encompass 99% of Ford related posts, please select and use the correct one. If anyone is not sure of which area to post something then feel free to P/M myself or other Senior Staff for guidance. The Moderating Staff are having to spend far too much time chasing this problem instead of maintaining the other areas of the forum.


zot

Budding Enthusiast
  • Content count

    2
  • Joined

  • Last visited

About zot

  • Rank
    Newbie

Profile Information

  • Ford Model
    Focus Edge
  1. Sorted! Having now fixed it, here are some handy hints if anyone else out there has the same problem in future: I decided I probably just needed to get more pressure on the piston to help it move back, but I was stuck for a while about how to hold everything in place so I could get the force required. I thought about bolting the caliper back in position to hold it while I worked on it, but the brake disc was in the way. So I removed the disc (marking which lug went through which hole so I could put it back where it came from), then bolted the caliper back in place. This left just enough room to get some thin-nosed pliers in to turn the piston head, and with a block of wood behind the caliper to stop it moving, I was able to screw the piston head while getting a lot more weight behind to push the piston back in as it turned. It then only took a few turns (clockwise) before the piston was fully retracted, and with each turn it was clear that the piston was moving. (Then remove the wood & unbolt the caliper to continue fitting as normal) Of course, using the right tool for the job in the first place would have helped! :-) Jason
  2. Hi, I'm attempting to change the brake pads on the rear of my Focus. I've done this before many times on different vehicles, but never before on a Focus. I checked out the process in the Haynes manual before I started, and have removed the old pads, but I'm stuck trying to retract the piston into the caliper. I can rotate the piston head and am trying to apply pressure as well but it seems it's just not doing anything. (I don't have the proper tool for this but I've never had any problems in this respect on previous vehicles. Is this a case where it'll be impossible without the correct tool? Haynes say simply turning with pliers should suffice) Can anyone confirm the exact process for this (i.e. do I need to apply pressure as I turn, should I turn clockwise or anticlockwise, and as a general guide how many turns are likely to be necessary - a few, or lots?) Please help if you can, as I'm stuck with a 3-wheeler until I can resoolve this problem! :-( Thanks, Jason