• Announcements

    • Stoney871

      Posting in General Chat thread.   11/11/2017

      it has been noted that too many Members are posting messages in the General Chat area instead of the correct Forums. Any messages posted in the General Chat area that are not General Chat will be deleted without warning and offenders may recieve warning points if repeated instances are seen from that Member. There are plenty of different Club areas that encompass 99% of Ford related posts, please select and use the correct one. If anyone is not sure of which area to post something then feel free to P/M myself or other Senior Staff for guidance. The Moderating Staff are having to spend far too much time chasing this problem instead of maintaining the other areas of the forum.


mudma

Budding Enthusiast
  • Content count

    4
  • Joined

  • Last visited

About mudma

  • Rank
    Newbie

Profile Information

  • Ford Model
    fiesta
  • UK/Ireland Location
    Greater London
  1. Cam Belt Change On A 1.25 Zetec-Se

    Well on my ecotec se 1.4 ther wasent anway to slacken old tensioner,just had to slide it off carefully,new tensioner did have the pin to lock it up, the aux/alternator belt is the stretch belt not the cambelt.I got that on n off with a screwdriver and gently levering it off as I turned engine by hand. Main thing is,crankpulley bolt! Tourque it up properly using a new bolt and threadlock,if u can get it off! If it winds out when running,as all pulleys are keyless,good bye valves with poss piston crown damage too.
  2. Cambelt Change

    Done my zetec se 1.4. yesterday,used the locking tool(small pin goes in hole to left of crankpulley,u should be undoing a bolt with a short fat stub on the end and you got the right one) I done crank locing pin first,then the cam locking bar,had to tease the exhaust cam over a touch to fit which is fine if its a tiny amount,use spanner on camshaft,slacken cam pulley bolts,dont use setting pin to hold crank it will break,same for the cam pulley bolts ,then you are supposed to slacken crank pulley bolt by lockin up crankshaft properly(i cowboyd it by cutting cambelt cover down and breaking lower part away slowly,bad I know lol)then support engine on trolley jack,undo engune mount( breaks down to three pieces)i had no way to slacken tensioner off as there seemed to be no locating pin apperature??, slid belt of v.carefully as the cam pulleys are plastic and very brittle,new belt on,new tensioner on,run new belt on going crank anticlock wise,pull pin out of new tensioner(this one had the locating hole)belt tensions and all pulleys turn slightly,do up pulley bolts,new one for crank with locktite if you have removed,remove locking tools,spin by hand to cheack all ok,check cam and crank setting tools fit,engine mout on,cover on done. All seems good,off to mcy ds!
  3. Duratec Zetec?

    So my 1.4 duratec is a duratec even tho it says ecotec se under the air.cleaner/filter? Lol
  4. Clicking Noise On Startup

    Ive got the same issue, 1.4 duratec(ecotec se under airbox) just changed oil and filter,still there. Def sounds like its from timing cover area,poss the rollers or tensioner,are they belt or chain?
  5. Welcome to the Ford forums mudma :)