• Announcements

    • Stoney871

      Posting in General Chat thread.   11/11/2017

      it has been noted that too many Members are posting messages in the General Chat area instead of the correct Forums. Any messages posted in the General Chat area that are not General Chat will be deleted without warning and offenders may recieve warning points if repeated instances are seen from that Member. There are plenty of different Club areas that encompass 99% of Ford related posts, please select and use the correct one. If anyone is not sure of which area to post something then feel free to P/M myself or other Senior Staff for guidance. The Moderating Staff are having to spend far too much time chasing this problem instead of maintaining the other areas of the forum.


gesdim

Budding Enthusiast
  • Content count

    2
  • Joined

  • Last visited

About gesdim

  • Rank
    Newbie

Profile Information

  • Ford Model
    Fiesta 1.3i JJA
  1. today I'm find solution...I find and built Belt tension pulley SKF VKM34034, without sleeve , and increase washer hole (from M8) to M10 bolt... in the original overhead roller, I'm change previous (simple) bearing with new Koyo bearing (with plastic cage) and of course change the old belt..
  2. Two days ago i had a problem with my car, with steering and battery charging..I thought at the beginning that the belt is broken and went yesterday in the nearest service..but the craftsman told me that the bottom, tensioner roller is lost; it's was replaced in 2002 , before 40.000km (~25.000m)..in that time the roller was manufactured from aluminum because local shop's didn't have the roller.Yesterday I went to Ford service, but they told me that car is very old (1996) and now by Ford exist only expensive (220Eu) complete tensioner with roller, and separately only overhead plastic roller. I'm in confusion because my original overhead roller is from steel, isn't plastic. My car is 1.3i/50HP,EFi OHV, first user buy car in Germany, on July 1996 ; car have 1 belt and hydraulic steering(pump), alternator and cooling pump, without climate system. I need help with information if exist roller from another car which can be built on tension shaft. Can I built any roller fi70mm x 21mm(25mm) ?? I've threw original broken roller and lost picture of manufactured roller. I need correlation between ribbed belt long and overhead and bottom rollers diameter. regards and sorry about bad grammar..