• Announcements

    • Stoney871

      Posting in General Chat thread.   11/11/2017

      it has been noted that too many Members are posting messages in the General Chat area instead of the correct Forums. Any messages posted in the General Chat area that are not General Chat will be deleted without warning and offenders may recieve warning points if repeated instances are seen from that Member. There are plenty of different Club areas that encompass 99% of Ford related posts, please select and use the correct one. If anyone is not sure of which area to post something then feel free to P/M myself or other Senior Staff for guidance. The Moderating Staff are having to spend far too much time chasing this problem instead of maintaining the other areas of the forum.


Geo2009

Budding Enthusiast
  • Content count

    2
  • Joined

  • Last visited

About Geo2009

  • Rank
    Newbie

Contact Methods

  • First Name
    George

Profile Information

  • Ford Model
    Focus CC3
  • Ford Year
    2014
  • UK/Ireland Location
    Ayrshire
  1. Hi, Yup after a bit of investigation I have found that the motors in the xenons are 2 phase stepper motors which explains the 4 wires and the motors in the Halogens are servo motors so only 3 wires. So as my car doesn't have the wiring for the stepper motors then its either make a driving circuit board to run the stepper motors or get some manual type servo motors and fit them into the xenon headlights. So Haz do you have a set of manual motors for sale?? Geo.
  2. Hi, Im having ago at fitting Xenon headlights to my Focus CC. Iv'e got the Xenon lamps to light and Im now trying to work out what I need to do to make the leveling motors to work. Does anyone know what signals/voltages the motors need to function and what pins on the headlamp connector they are feed into? With a bit of elimination I think pin 7 is (-ve) ground, pin 10 is (+ve) 12v but I can't work out what the other two pins, pins 5 & 9 require. Strangely I found that pin 5 is low resistance (0.6 ohms) to pin 7 and pin 9 is low resistance (0.6 ohms) to pin 10?? On the halogen headlamps pin 7 is -ve, pin 9 is the signal (0.6v to 12v) from the thumb wheel dash adjuster and the +ve for the motor comes from pin 2 inside the headlamp. If I can find out what the motors need to move then it should be possible to make a circuit to do it manually. Any help would be greatfully received. Geo.
  3. Welcome to the Ford forums Geo2009 :)