• Announcements

    • Stoney871

      Posting in General Chat thread.   11/11/2017

      it has been noted that too many Members are posting messages in the General Chat area instead of the correct Forums. Any messages posted in the General Chat area that are not General Chat will be deleted without warning and offenders may recieve warning points if repeated instances are seen from that Member. There are plenty of different Club areas that encompass 99% of Ford related posts, please select and use the correct one. If anyone is not sure of which area to post something then feel free to P/M myself or other Senior Staff for guidance. The Moderating Staff are having to spend far too much time chasing this problem instead of maintaining the other areas of the forum.


SteveZ

New Member
  • Content count

    1
  • Joined

  • Last visited

About SteveZ

  • Rank
    Newbie

Contact Methods

  • First Name
    Steve

Profile Information

  • Ford Model
    Focus
  • Ford Year
    2000
  • UK/Ireland Location
    Cornwall
  1. Rear Wiper Problem

    I have just restored the self-parking to the rear wiper on my 2000 Focus 1.6 and you might be interested in how to do it.If the wiper moves at all when you switch it to the interval wipe, the timer unit is sending the pulse to the motor, which starts the wiping action, The rest of the wipe is controlled within the wiper motor by a circular contact plate with a section missing. This missing section stops the wiper motor at the self-parking position by interrupting the earth contact. To fix it, make sure the wiper is parked where on the screen where you want it tp park in future. Remove the wiper body and strip it down. Fairly simple, but you have to remove the rear door trim to get at the fixings. The 4 screws are fine, but levering the clip fixings are tricky - take it easy or they might break. Remove the wiper arm to allow the removal of the motor/gearbox assembly. Note the washer and small 'O' ring position. Mark the position of the nylon geared ring againt a marked point on the housing. A spot of paint will do. Make sure the marks line up on reassembly Remove the screws (small Torx) from the gearbox cover plate and drive out the wiper shaft with a wooden mallet. Note the small nylon cap and the wavy spring washer positions. My circular plate was covered with a mixture of rust, dirt and grease!!. Clean the plate with wet or dry until smooth and clean. Clean and grease the gear teeth and all bearing points and reassemble everything. I didn't grease the cleaned up plate but doing that might help prevent the plate corroding again - up to you. Good Luck - it is worth the effort to have the wiper parking properly again!
  2. Welcome to the Ford forums SteveZ :)