• Announcements

    • Stoney871

      Posting in General Chat thread.   11/11/2017

      it has been noted that too many Members are posting messages in the General Chat area instead of the correct Forums. Any messages posted in the General Chat area that are not General Chat will be deleted without warning and offenders may recieve warning points if repeated instances are seen from that Member. There are plenty of different Club areas that encompass 99% of Ford related posts, please select and use the correct one. If anyone is not sure of which area to post something then feel free to P/M myself or other Senior Staff for guidance. The Moderating Staff are having to spend far too much time chasing this problem instead of maintaining the other areas of the forum.


fratello

Budding Enthusiast
  • Content count

    29
  • Joined

  • Last visited

About fratello

  • Rank
    Member

Contact Methods

  • First Name
    Dan

Profile Information

  • Ford Model
    FF MK3
  • Ford Year
    2018
  • UK/Ireland Location
    Other/NonUK
  1. Steering assist malfunction - Service required

    My battery have only 5 month, is genuine ... so I think it's not responsable for this issue.
  2. Steering assist malfunction - Service required

    Me too, same issue !!! Any advice appreciated !!! Regards !
  3. Re Attaching Rear Door Weather Seal

    " The TSB describes the procedure to cut the reinforcement wires at a few particualr locations to eliminate the tension on the wire. " Where are these reinforcements located ? Thanks !
  4. dash clocks flickering & pulsing

    How old is the battery ? Without the lights on, is it the same ?
  5. FORScan

    I think so ... http://www.forscan.org/forum/viewforum.php?f=6
  6. This schematic is OK ?? SYNC I wiring.pdf
  7. Thanks, again :) ! " This is the schematic of the old Bluetooth/Voicecontrol system. The old Bluetooth/Voicecontrol system is completely different from the newer 1st generation SYNC system. " For my components it's another schematic ??? I "build" my cable according to this schematic (and the schematic I draw in post above) :( ...
  8. Thank you so much for the very documented responses ! " You need to splice your MM-CANbus APIM wiring the correct way into the MM-CANbus network wiring. ". Where can I properly connect these two wires ?? " Connecting the ground wires of the APIM module directly to the ground wires of the ACM can result in interference " Where can I properly connect this ground wire ? " additional FM/AM antenna with amplifier " . What is the code for this antenna ? Regards !
  9. After long searching, I managed to gather all the components I need for upgrading to Sync I my stock base radio on FF MK3 : -display E1BT-18B955-DA -radio-cd BM5T-18C815-GN -bluetooth BM5T-14D212-DC I made the cable according to the schematic. I'm ready now to put it in the car ... but I need some answers before that : -is the schematic (see above) OK ? -the hole for display cooling "system" is 10 mm diameter ? -what are the steps to write the new parameters with Focccus ? -should I watch out for anything special ? Any other advice is welcome ! Thanks ! Regards !
  10. Mk3 glovebox removal

    Don't give up !
  11. Mk3 glovebox removal

    @ Kingsblue : See :
  12. Focsum MK3 1.6l Ti-VCT engine tremble issue

    Unfortunately, I have not solved anything ... I still gather information, how to identify the cause of the problem and what is the solution. The polish guys from fordserwis.com.pl say : "We can not send you how solve problem without car.We have to perform diagnostics of the car - this is possible only in our garage."
  13. Focsum MK3 1.6l Ti-VCT engine tremble issue

    Sorry ... new link : I found another interesting site, where is presented the same (??) problem : http://www.fordserwis.com.pl./awaria_sterownika_pcm_w_focusie_mk3_1_6_benzyna,Awaria-sterownika-PCM-w-Focusie-MK3-1.6-benzyna
  14. This is full diagram of connections. Maybe is usefull for someone ...