Jump to content


Photo

Fitting Reversing Sensors


  • Please log in to reply
1 reply to this topic

#1 Thunderguts

Thunderguts

    Settling In Well

  • New Member
  • PipPipPip
  • 34 posts
  • Ford Model: Mondeo Edge 1.6 125

Posted 20 October 2010 - 05:13 AM

Morning all, advice needed here, I have a 57 plate Mondeo Edge, and I've just aquired a set of 4 reversing sensors(3rd party) I have planned for them to fit into the plastic strip under the bumper(where ford put them) but do I have to trace a wire from the tail gate upto the roof then down to the boot compartment (planning on putting box and buzzer next to fuse box). Or can I access the reversing light wires from the boot fuse box area? The wires must access the boot somewhere but where?

Thanks in advance.

Have something to contribute?

Sign in or register to start a topic...



Sign up to FOC Premium Membership To Remove These Ads

#2 Thunderguts

Thunderguts

    Settling In Well

  • New Member
  • PipPipPip
  • 34 posts
  • Ford Model: Mondeo Edge 1.6 125

Posted 22 October 2010 - 02:11 AM

Job done easy as, if anyone is gonna try this, easy access to reversing light wire is to remove the left hand side gator that connects the tailgate to back of car and it's the green/brown wire! Saves running a wire all the way down the tailgate.

Total cost of 25! Sensors 15, wire, connectors, tape, switch (just incase), cable ties, 10! Took just over 2 hours well pleased with result


Not what you're looking for?

Register now, we have a huge community of enthusiasts to answer any questions you might have



0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users