Jump to content


Photo

Engine Management


  • Please log in to reply
2 replies to this topic

#1 Smith28

Smith28

    Member

  • New Member
  • PipPip
  • 26 posts
  • Name: Steven
  • Ford Model: Ford focus 1.6 16v zetec SE hatchback
  • Year: 2002
  • Location: Durham

Posted 18 September 2011 - 02:37 PM

Hi. I've got a focus 1.6 zetec 2002 model.

Today I've been trying to put a tail pipe on the end of my exsaust. I got it on then when I went out to drive car my engine management light stayed on.

I then got told if I disconnect the battery it should go out and reset. Do I did it. When I started car up sure enough it stayed out. BUZZIN. "So I thought". Cause when I went bk out a hour later there was the light bk on again.

No loss in power and drives fine. But every time I take battery off for 10 seconds and start the car it keeps going out until I take key out and start it bk up.

Has any of my fellow focus or ford owners have any idea what on earth is going on??
Any solutions and replys much appreciated :-)

Have something to contribute?

Sign in or register to start a topic...



Sign up to FOC Premium Membership To Remove These Ads

#2 stef123

stef123

    Ford Enthusiast

  • Management
  • 5,806 posts
  • Name: Stefan
  • Ford Model: Mondeo ST TDCI
  • Year: 2006
  • Location: Scotland
Contributor

Posted 18 September 2011 - 03:04 PM

what sort of tail pipe were you fitting? just a bolt on job or was it a weld on type?

#3 Smith28

Smith28

    Member

  • New Member
  • PipPip
  • 26 posts
  • Name: Steven
  • Ford Model: Ford focus 1.6 16v zetec SE hatchback
  • Year: 2002
  • Location: Durham

Posted 18 September 2011 - 03:05 PM

Just a bolt on tip m8


Not what you're looking for?

Register now, we have a huge community of enthusiasts to answer any questions you might have



0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users