GSM Posted June 16, 2012 Share Posted June 16, 2012 Hi all, I've got a 2006 Focus Ghia 1.6 and having some issues with the heated front windscreen. Half of the screen seems to work (passenger side), whilst the other half doesn't work at all. I'm assuming that the mechanism is split into two circuits at some point and that the side controlling the drivers side is faulty/disconnected/fuse issue somewhere. Just wondering if anybody knows where to look and how to test for problems? Quote Link to comment Share on other sites More sharing options...
Stoney871 Posted June 16, 2012 Share Posted June 16, 2012 This is a common fault with the Focus. There is a copper ribbon under the scuttle panel that gets caught by the wiper motor link and gets damaged. If you search the forum you will find previous threads concerning the cause and solution. Quote Link to comment Share on other sites More sharing options...
stef123 Posted June 16, 2012 Share Posted June 16, 2012 It might also be worth checking the connector under the scuttle. When my mondeo screen stopped working on one side, I traced it back to a bad connection. Cleaned and tightened the pins, it's been fine since 1 Quote Link to comment Share on other sites More sharing options...
NorthSussex Posted June 16, 2012 Share Posted June 16, 2012 I've also had the same problems on a Granada and a Mondeo, it's always the drivers side that packs up, it,s about time Ford sorted this one. Quote Link to comment Share on other sites More sharing options...
mintalkin Posted June 16, 2012 Share Posted June 16, 2012 also check the fuse for the non working side. Quote Link to comment Share on other sites More sharing options...
artscot79 Posted June 16, 2012 Share Posted June 16, 2012 i had a look under mine and the copper wire is at the front on top of the metal not hanging under like the ones ive seen the wiper goes nowhere near so im not sure its been a ford issue. Quote Link to comment Share on other sites More sharing options...
NorthSussex Posted June 17, 2012 Share Posted June 17, 2012 i had a look under mine and the copper wire is at the front on top of the metal not hanging under like the ones ive seen the wiper goes nowhere near so im not sure its been a ford issue. I hope you're right Arthur, I would be miffed it it happened to me for a third time on 3 different Ford models. . Quote Link to comment Share on other sites More sharing options...
GSM Posted June 24, 2012 Author Share Posted June 24, 2012 i had a look under mine and the copper wire is at the front on top of the metal not hanging under like the ones ive seen the wiper goes nowhere near so im not sure its been a ford issue. It must be some sort of design fault given the frequency of the fault... seems to be everywhere! Might not be the wiper thing, but might just be the use of cheap/poor quality wiring. Quote Link to comment Share on other sites More sharing options...
NorthSussex Posted June 24, 2012 Share Posted June 24, 2012 It must be some sort of design fault given the frequency of the fault... seems to be everywhere! Might not be the wiper thing, but might just be the use of cheap/poor quality wiring. I agree, it happened on both of my last 2 Fords, drivers side packing up, fingers crossed for this Focus. Quote Link to comment Share on other sites More sharing options...
artscot79 Posted June 24, 2012 Share Posted June 24, 2012 the wiring sits right on top of the area where the rain runs down to the drain under the scuttle panel and gets a lot of muck on it the wiring looks like copper so should last. had a look at mine just last week and alls fine where they are situated. it could be either when screens are replaced these ribbons are not sited correctly which is where the wiper gets it or some arent done at the factory. 2focus and no issue with either in laws c max no issues and both neighbours foci no issues all 2005 to 2007 Quote Link to comment Share on other sites More sharing options...
NorthSussex Posted June 24, 2012 Share Posted June 24, 2012 the wiring sits right on top of the area where the rain runs down to the drain under the scuttle panel and gets a lot of muck on it the wiring looks like copper so should last. had a look at mine just last week and alls fine where they are situated. it could be either when screens are replaced these ribbons are not sited correctly which is where the wiper gets it or some arent done at the factory. 2focus and no issue with either in laws c max no issues and both neighbours foci no issues all 2005 to 2007 That sounds reassuring. :) Quote Link to comment Share on other sites More sharing options...
GSM Posted June 24, 2012 Author Share Posted June 24, 2012 Opened it up and had a look at mine today. The ribbon was completely detached from the wire - that's the problem. Not sure how it happened though, hard to see how it had been routed since they were just completely detached. Soldered them together and are hoping for some good conditions to test it soon... although knowing my luck it'll probably be lovely and sunny with no steamy windows for a good while. Quote Link to comment Share on other sites More sharing options...
Beaker Posted March 31, 2015 Share Posted March 31, 2015 Well, fixed all that, but no power to the connector plug on the car side any clues ? Quote Link to comment Share on other sites More sharing options...
Stoney871 Posted March 31, 2015 Share Posted March 31, 2015 Fuse? Each side is fused seperately I believe. Quote Link to comment Share on other sites More sharing options...
Beaker Posted April 1, 2015 Share Posted April 1, 2015 Is it possible for one side of a relay to go down ? Quote Link to comment Share on other sites More sharing options...
STEADS Posted April 1, 2015 Share Posted April 1, 2015 I'd of thought it would have two relays not just one I'm sure the like of the Galaxy has i now my Range Rover has so should imagine these have if its split to different circuits . Quote Link to comment Share on other sites More sharing options...
Tommi97 Posted July 16, 2023 Share Posted July 16, 2023 On 6/16/2012 at 11:34 AM, stef123 said: It might also be worth checking the connector under the scuttle. When my mondeo screen stopped working on one side, I traced it back to a bad connection. Cleaned and tightened the pins, it's been fine since How did you go about doing this fix please, as I’d like to see if this will sort my passenger side heated screen not clearing Thanks Quote Link to comment Share on other sites More sharing options...
Tommi97 Posted July 17, 2023 Share Posted July 17, 2023 On 6/16/2012 at 11:34 AM, stef123 said: It might also be worth checking the connector under the scuttle. When my mondeo screen stopped working on one side, I traced it back to a bad connection. Cleaned and tightened the pins, it's been fine since What is the best way to try this fix please as I’d like to see if this sorts the one half of my heated screen Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Ford UK Shop
Sponsored Ad
Name: eBay
Ford Model: FordUK Shop
Ford Year: 2024
Latest Deals
Ford UK Shop for genuine Ford parts & accessoriesDisclaimer: As the club is an eBay Partner, The club may be compensated if you make a purchase via the club
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.