Ford Owners Club - Ford Forums Messages

Club Announcements

Ford Fair 2016: Tickets and stand passes are now available to purchase. More info here.

Review your Ford: Help others when it comes to buying a car like yours and review your Ford now

Ford Car Parts: View All ford car parts by category. Look for Ford Car Parts now!

AdBlock Warning

Parts of this website do not function properly with AdBlock enabled on your device. To get the best user experience on our website, please disable Adblock for this website (domain) on your browser.


k13r4n

Xenon Parts Requirement

35 posts in this topic

sorry the control module you will need to source, what you are looking for up in the footwell is a socket to plug the box into.

An easier way to find out if you have it would be to remove the A pillar plastic trim, which leaves a gap for you to look down behind the air blower (drivers side) and you should either see not alot or a grey coloured foam tape covering an electrical socket. I will post some pics tomorrow

Also if you look on the inside of the bumpers, the holes are already marked out, just like the rear parking sensors are in the back bumper

Share this post


Link to post
Share on other sites
 

what you are looking for up in the footwell is a socket to plug the box into.

An easier way to find out if you have it would be to remove the A pillar plastic trim, which leaves a gap for you to look down behind the air blower (drivers side) and you should either see not alot or a grey coloured foam tape covering an electrical socket. I will post some pics tomorrow

would this be on my mk2 ghia too?

Share this post


Link to post
Share on other sites

To be fair mate, from what was said above it seems ford have a mind of their own when it comes to the different wiring looms so all I would say is check it out. If you have the wire in the engine bay for the front levelling sensor it would be silly if you didn't have this connector. All depends on what Ford decided to do.

I will try and get some pics tomorrow to help you all find the right bits :)

Share this post


Link to post
Share on other sites

Ok cheers in advance haz and found the four way connector beside the bonnet holder

Share this post


Link to post
Share on other sites

Wire beside water bottle is pic 1 pic 2 is the wire to drivers light it has 10 wires going in

post-32783-0-70640600-1350580169_thumb.j

post-32783-0-51345600-1350580203_thumb.j

Share this post


Link to post
Share on other sites

Erm this is under the light behind the arch bit beside my water bottle and think this is the wiring loom code rb2004

Share this post


Link to post
Share on other sites

Erm this is under the light behind the arch bit beside my water bottle and think this is the wiring loom code rb2004

post-32783-0-25899900-1350582913_thumb.j

post-32783-0-62906200-1350582943_thumb.j

Share this post


Link to post
Share on other sites

Yeah that's the socket for the washer bottle. If that has about 4 or more wires going to it then it should work with the ST front bumper washers too.

Looks like your wiring is the same as mine then :)

Share this post


Link to post
Share on other sites

I'll have to check this tomorrow

Share this post


Link to post
Share on other sites

Ok so all I would need to do is source parts and wire it all up

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now