Ford Puma- Rust On Rear Arch Paint Work- Diy Help.?
Posted 21 October 2012 - 08:57 AM
Am looking at doing it DIY as pritty good but wonderd if anyone has ever tackled this probblem them selves an if so have you any tips..? jb
oh an if any one knows y i cant get warm air as im freezing .
Posted 21 October 2012 - 09:18 AM
Posted 21 October 2012 - 10:03 AM
As oilburner say's, most likely cause of your heating issue is the HCV. However I would check the electrical connection to the HCV to see what voltage you are getting there. If I remember rightly they normally get stuck in the open position which allows heat through. The voltage should be next to nothing when the control knob is set to hot, and 12v when set to cold (may be the other way round as its been a long time since I messed with one). If the voltage is not changing, then the heater control panel which is attached to the rear of the control knob may need changing.
Posted 21 October 2012 - 10:49 AM
Posted 21 October 2012 - 10:51 AM
Posted 21 October 2012 - 11:17 AM
When it goes black you can sand it again and then add filler, smooth off and then prime and repaint.
Posted 21 October 2012 - 02:18 PM
Sorry I cant rember for sure as it was a long time ago. I think I took the stereo out first and pulled the whole dash out with the control knobs still attached and then unscrewed them from the back. And yes the knob should pull off (excuse me vicar).
so how would i access theheater control panel then..? pull of the knob selector on dash..? an it shud be behind that.? cheers
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users