dunno if your still about here mate but i've just bought the same mondeo unit as you
how did you go about fitting it? like did it fit in easy enough cause i'm looking at it n thinking it'll be too long
did you cut the hole bigger straight back from the existing hole if you get what i mean? or did you have to cut the existing hole further forward to mount the unit further forward?
Still ere mate!
It's not too bad to fit but you gotta be careful..
You do need to do a bit of cutting . First I took the black 'back box' and light unit out of the sunglasses holder so you just have the grey plastic surround , next I took the old unit out of the headlining . Then I slid the front of the mondeo unit in place (think I had to open the front clips a bit) it needs to go as far forward as possible but be careful as i pushed a bit too hard and slightly creased my headlining.
Once I'd got that far then I just measured how far back I needed to cut and marked it on the headlining.
Be really careful when cutting as I had a loom taped right where the cuts go so have a feel about in there before you do.
The sunglasses end is a real tight fit as the headlining is too thick so it also needed a bit of the foam backing trimming down . If you don't trim enough off you can't clip the backbox back on the interior unit .
Hope that kinda makes sense and good luck . I think there was a great fiesta guide on here somewhere but I can't find it now