It's going to be a long battle i can tell haha
Anyway Pod has arrived , minus the top section , which i figured as much as the picture's never showed it , but it was a good buy.
So off to Ford and ordered the top section £58 for the £1.50 bit of plastic trim , rip off merchants lol.
I will have that by next friday as it has to come from Germany.
I tried the Pod in place , and i will have to cut away small sections where the speak cover clips in , not a problem. i will either have to move the centre speaker or leave it out as the dash pod only has a small place for a tweeter.
So for now i will test the Pod wiring connections to see if i can get it to light up at least while i search for any wiring diagrams for the ST which are like Hens teeth.
If that fails completly then at least i still will have the Pod for which a Scan gauge should fit in or some 35mm guage's perhaps , so not all is lost.
I have also thought of ,an Android phone loaded with torque pro and sit that inside the gauge. So even if i can't get it working as is , then at least i can investigate other possiblilties.