Jump to content
Do Not Sell My Personal Information

Higgsy's Zetec S Thread


higgsy
 Share

Recommended Posts

looks a good match and im sure once its put on it will look good

  • Like 1
Link to comment
Share on other sites


yeah looks pretty good match, I did what ben did and didn't flat the basecoat before clearcoat, the texture/finish of the ba.secoat was such that I didn't think it needed it. I also applied clearcoat 3 hours after basecoat. There are loads of threads on the internet regarding spraying and as per usual with the internet they contradict each other! Although most seemed to point towards clearcoating an hour or 2 after basecoat. Anyway the finish is good the way I have done it, just a few specks of dust here and there, that i need to sort out.

My method was:

Bought replacement bonnet lip

Sanded down with P400 wet/dry to key

Used Hycote grey plastic primer - 5 thin coats

Waited 24hrs - Then rubbed down/smoothed primer with ultra fine (light grey) scotchbrite pad

Wiped with damp cloth, then wiped down with isopropyl alcohol

6 thin coats/passes of genuine ford basecoat until the can ran out.

Left 3-4 hours - wiped over with lint free cloth/isopropyl alochol lightly to remove dust etc

6 thin coats/passes of ford clearcoat.

The ford cans (150ml) are just enough to do one of these bonnet lips, I could have quite easily done a couple more light passes of both cans.

The key here is to get the primed article as smooth and flaw free as possible before basecoat.

Gonna give it a few days and then clay/polish it lightly before fitting to the car, but no orange peel or anything at moment so all good!

  • Like 2
Link to comment
Share on other sites

That hycote stuff is awesome primer, I use it all the time ;) looking good

  • Like 2
Link to comment
Share on other sites

Bonnet lio fitted. Looks the dogs nadgers!

IMG_20140815_130416-picsay_zpslsqcrsew.j

  • Like 4
Link to comment
Share on other sites

Bonnet lio fitted. Looks the dogs nadgers!

IMG_20140815_130416-picsay_zpslsqcrsew.j

Where did you get that grill from? Looks much better than my titanium one.

  • Like 1
Link to comment
Share on other sites


Where did you get that grill from? Looks much better than my titanium one.

Standard zetec s upper/lower grille mate
  • Like 2
Link to comment
Share on other sites

Would the lower grill fit straight into my titanium bumper?

  • Like 1
Link to comment
Share on other sites

liking the bonnet trim looks much better colour coded and imo ford should have done it that way from the factory

  • Like 2
Link to comment
Share on other sites

Looking great Higgsy! Im tempted to paint mine now lol!

I take it you have already ordered your ST upper grille? :p

Sent from my iPhone using Ford OC mobile app

  • Like 2
Link to comment
Share on other sites

liking the bonnet trim looks much better colour coded and imo ford should have done it that way from the factory

Agreed mate

  • Like 1
Link to comment
Share on other sites


Looking great Higgsy! Im tempted to paint mine now lol!

I take it you have already ordered your ST upper grille? :p

Sent from my iPhone using Ford OC mobile app

Do it mate only cost 40 to do - still have my old lip as a spare, leaving the grilles as is tho.

  • Like 1
Link to comment
Share on other sites

Did you pick a new lip up from ford? Yeah its well worth £40 mate makes the front end look so much better!

Sent from my iPhone using Ford OC mobile app

  • Like 1
Link to comment
Share on other sites

Did you pick a new lip up from ford? Yeah its well worth £40 mate makes the front end look so much better!

Sent from my iPhone using Ford OC mobile app

Na, 20 quid non genuine from eBay, then 20 for primer/genuine ford paint.

  • Like 2
Link to comment
Share on other sites

Looks good mate, the non-genuine lip I got didn't fit the recess on the bonnet so painted the original. :-)

Sent from under the bonnet

  • Like 3
Link to comment
Share on other sites

Bonnet lio fitted. Looks the dogs nadgers! IMG_20140815_130416-picsay_zpslsqcrsew.j

focus is looking great james some fantastic work done keep it up mate LHD reverse unit would look great on the rear aswell as additional boot light on opposite side,

See my profile page for links to the Guides if required,

  • Like 2
Link to comment
Share on other sites

focus is looking great james some fantastic work done keep it up mate LHD reverse unit would look great on the rear aswell as additional boot light on opposite side,

See my profile page for links to the Guides if required,

I think this will be my next mod - got the stuff on my eBay watch list for it, plan to do it before the dark nights, within the next 6 weeks or so I think, goona use your guide fo sho geezer

  • Like 1
Link to comment
Share on other sites

I think this will be my next mod - got the stuff on my ebay watch list for it, plan to do it before the dark nights, within the next 6 weeks or so I think, goona use your guide fo sho geezer

:lol: you da man bro!
Link to comment
Share on other sites

Link to comment
Share on other sites

That's where mine is from, good quality and fit is spot on. :-)

Sent from under the bonnet

  • Like 1
Link to comment
Share on other sites

That's where mine is from, good quality and fit is spot on. :-)

Sent from under the bonnet

Do you notice that when you take a picture: the reflector on the genuine one shines but the clear lensed unit doesn't reflect as good?

Minor detail but just my observation,

The non Genuine ones are sold for around 12 pounds in china, so whatever there selling them on eBay for, is pure profit,

For the extra 7 pounds id go genuine but each to there own.

Link to comment
Share on other sites

Latest Deals

Ford UK Shop for genuine Ford parts & accessories

Disclaimer: As the club is an eBay Partner, The club may be compensated if you make a purchase via the club

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share







×
×
  • Create New...

Forums


News


Membership