Will this fit?

[ayrshiredude]

Can anyone tell me if this will fit my Fiesta Zetec S Red Edition?  

 

[ayrshiredude]

Any ideas?

[alexp999]

Depends where it is from.

If it is from a Fiesta then yes, not sure on fitting from other models.

I checked my dad's and it has the ambient lighting feed, so we are going to change his at some point.

[Stoney871]

Should fit but easiest way to be sure is pull the existing light out.

If it's a light with a rear housing attached rather than just a hollow lens with flip out bulb holders/reflectors then you're all good.

As the one in the picture is one with ambient lights in it you need to run a small bayonet connector from a comtact that is about 4mm sticking out of the back and connect a wire to the rear of your headlight controller on the wire that links your numberplate illumination supply.

Sent from my SM-G930F

[ayrshiredude]

On 19/08/2016 at 11:02 PM, Stoney871 said:

Should fit but easiest way to be sure is pull the existing light out.

If it's a light with a rear housing attached rather than just a hollow lens with flip out bulb holders/reflectors then you're all good.

As the one in the picture is one with ambient lights in it you need to run a small bayonet connector from a comtact that is about 4mm sticking out of the back and connect a wire to the rear of your headlight controller on the wire that links your numberplate illumination supply.

Sent from my SM-G930F

I took it out and it has a lot or bronze metal lines behind it with the 3 bulb holders as well.  I seem to remember reading that the Zetec S has a power wire sitting behind the plate but I removed the whole plastic surround and couldn't find anything there.

I don't really fancy having to do complicated wiring so would this mean its not gonna work?