Jump to content


james_60

Member Since 01 Jan 2010
Offline Last Active Apr 23 2014 02:56 PM
*****

#346994 Mk7 - St Vs 1.0T Ecoboost Realistic Motorway Mpg?

Posted by james_60 on 24 March 2014 - 10:29 PM

Then if you cannot afford to run the car then dont buy it simples

 

Jamie




#344599 Facelift Focus - Mk3.5

Posted by james_60 on 18 March 2014 - 11:52 PM

i love that saloon model focus :-)

 

Jamie




#344564 Bye Bye Fiesta

Posted by james_60 on 18 March 2014 - 10:41 PM

Hiya

 

That new car is beautiful :-)

 

Love it

 

Jamie




#344546 Rapid Decrease In Fuel When Around 50 Miles Remain

Posted by james_60 on 18 March 2014 - 10:28 PM

Wait until it has done at least 10-12k before trying for good mpg results

 

Jamie




#342876 Guide For Focus Mk2/mk2.5 C-Max/kuga ~Elm 327 Cable And Ff2 Program

Posted by james_60 on 14 March 2014 - 07:34 PM

Jamie what speed does the auto locking kick in ?

I downloaded today but have not tested the program yet.

 

Hi Paul

 

It locks the doors between 5-10 mph i have not got an accurate speed,

 

but its good, i trust it, and it works every time

 

:-)

 

Jamie




#340157 Focus Bulb Lists

Posted by james_60 on 08 March 2014 - 02:22 PM

Hi

 

Unfortunately your incorrect

 

The Hid system is D3S 35W made by osram

 

Then there is a h7 bulb and a h1 bulb

 

I just changed my h7's to philips extremevision's

 

Jamie




#339911 Tyre Preasure

Posted by james_60 on 07 March 2014 - 08:08 PM

Hi folks

 

I was running on full load pressures for years until i got my mk3 focus's

 

It led to an unstable front end at high motorway speeds espech when wet and braking so dont be tempted to go tooo high

 

Jamie




#247385 Tyre Puncture

Posted by james_60 on 28 March 2013 - 01:55 PM

The Reason for not repairing them on the last 3mm or near the edge of the tyre is when the tyre is squidged about and around corners it could pop the repair out and then your back to square one.

 

Jamie




#151413 Guide To Fitting Smd Leds To Cup Holder

Posted by james_60 on 05 November 2011 - 06:50 PM

Hey Pre


That is one fab mod and i really like it.


I will pay ure fuel etc for you to come and mod the cupholders in my car:-)


Jamie


#149433 2010 Tdci Brake Upgrade ?

Posted by james_60 on 21 October 2011 - 06:28 PM

Hi Poshpaws


Why not convert the rear drum system to disc brakes


Jamie


#146673 Dash Storage

Posted by james_60 on 02 October 2011 - 11:33 AM

I will keep my supply of tissues and polo mints in there (damn now everyone knows about my mint addiction) :ph34r:

Maybe my phone charger


Jamie :-)


#136982 Fiesta 1.25 Or 1.4 - Petrol Versions

Posted by james_60 on 22 July 2011 - 06:27 PM

Both the 1.25 and the 1.4 engines share the same bore diameter.

The only difference to make up the CU is the Stroke on the 1.4 is slightly longer.

The 60ps and 82ps 1.25 engines have a 71.9 mm Stroke and a 76.5 mm Bore Diameter
The 96ps Engine has a 76 mm Stroke and a 76.5 mm Bore Diameter

The 1.4 PFI Sigma 96ps engine has advantages over the smaller 1.25 engine.

According to Etis the 1.4 engine is equipped with Port Fuel Injection whereas the 1.25 has Electronic Fuel Injection.

Now According to my knowledge Both are electronic but the main advantage is that the 1.4 has its injectors closer to the inlet ports on the engine.

So to Summerise, There are two Main Advantages for the 1.4 (1388 96ps) (Maybe Three)



  • Port Fuel Injection which is also Electronic
  • Slightly longer stroke (The Length of travel in MM that the piston has to move (Verticaly) inside the bore of each cylinder)
  • It could also posess an altered or different throttle body
I hope the Class has not fallen ASLEEP lol :blink:

Port Fuel injection has advantages :-

A type of fuel injection with at least one injector mounted in the intake port(s) of each cylinder.

Usually the injector is mounted on the air intake manifold close to the port.

Port fuel injection improves fuel distribution and allows greater flexibility in intake-manifold design, which can contribute to improved engine breathing.

Jamie :ph34r:








#132118 How Much Is My Car Worth

Posted by james_60 on 16 June 2011 - 09:31 PM

Tato I was just waiting for you to ask that i knew you had it in you lol

I would like a new car obviously but i want it to be slightly more powerfull.

Also I may want to Mountune it in the near future.
Would it be worth E-Baying it 9250 buy it now or best offer

Jamie


#96777 Fiesta Tyre Sizes

Posted by james_60 on 10 September 2010 - 03:40 PM

Hi

you got it spot on Posted Image

205/40 ZR17

Jamie


#95954 Flip Key

Posted by james_60 on 04 September 2010 - 05:41 PM

Hi Tone

As simple as it sounds it is not.

The new Key would have to be cut as you have said.

It would also need coding to the imobilisor on your car/van

Key and codeing you are looking atleast at 100

Jamie