Jump to content

  2. → Viewing Profile: Posts: handel18

Show

Support the club!

FOC Supporters Membership | Ford Owners Club Insurance | Club Moderators Needed | Ford Accessories

handel18

Member Since 23 Sep 2008
Offline Last Active Feb 25 2011 02:46 PM
-----

Posts I've Made

In Topic: Fitting A Sub

25 February 2011 - 12:41 PM

you may not even need the pics actually...

the grommet is visible from the engine bay just behind the battery to the left a bit. it is about 3" in diameter and sticks out into the engine bay, you can't miss it. the ford mechanic fed the cable through the top section of it and sealed it with silicon to keep it water tight. the cable then popped out in the passenger foot well.

In Topic: Fitting A Sub

25 February 2011 - 12:37 PM

Broxson - i had my car in for a service this week and asked the mechanic if he could run the cable through the bulkhead for me. He did it FOC as it was a very quick job. i've taken a few pics for you, don't know how to upload them here so if you give me your email address i'll send them over to you. it is for a 2006 tdci, but hoopefully the grommet will be in the same place on yours

In Topic: Fitting A Sub

18 February 2011 - 06:32 PM

I've read about routing it through the door somehow on fiestas, wondering if there was a way to do that on the mk2 focus. apparently that would be easier than finding the illusive grommet!

In Topic: Fitting A Sub

12 February 2011 - 09:14 AM

hi - did you figure this out? i'm trying to find out how best to get an amp cable through to the battery in my mk2 focus 2006

  1. Ford Owners Club - Ford Forums
  2. → Viewing Profile: Posts: handel18
  3. Privacy Policy