Jump to content


dorf

Member Since 31 Oct 2011
Offline Last Active Mar 12 2014 11:44 AM
-----

Posts I've Made

In Topic: Cleaning Fusion Throttle Body

12 March 2014 - 11:44 AM

I visited to Ford Dealer
They plug my Fusion on to the computer, nothing problem found on accelerator pedal or throttle body.
Then they tryed to update PCM program with nevest factory-updated software, but it refuse to install.
They Asked me to wait for newer update ( That is not yet published in )

Did anybody have similar Experience, with updating.


In Topic: Cleaning Fusion Throttle Body

27 February 2014 - 11:00 PM

Just cleaned throttle body, and check inside black cover.
All gears look o.k  and sensors surface looks good ( no carbon dust at all)
I did not put grease on  gears. 100 000km and gears looks like new.
But symptoms are same, nothing change. :blink:
There was litle valve touch mark on throat (in picture).
http://i61.tinypic.com/14vpuyq.jpg

Maybe it is accelerator pedal and yes... new pedal needs programming
i hate these fly by wire things :ph34r:

here is few photos

http://i58.tinypic.com/2rdc01j.jpg

http://i57.tinypic.com/1zexj42.jpg
 


In Topic: Cleaning Fusion Throttle Body

20 February 2014 - 05:42 PM

Thanks :) ..do you know what is throttle body bolt torque Nm?

Maybe i remove throttle body and clean it. i have Liqui Moly special cleaner for that.

That casket is expensive 29€ here in Finland ( everyting related cars is very expensive here :( )

but maybe it is better to order new one, if origal breaks or something.

i hope that i get body out between those inlet pipes.


In Topic: Fusion 1.6 Idle Speed Control Valve, Air Filter Housin Tubes

19 February 2014 - 09:52 PM

thank you


In Topic: Ford Fusion 1.6 Cambelt Snapped.

05 June 2013 - 01:07 PM

sorry to hear that, have you change cambelt earlier without changing the pulley.

How many kilometers driven?