leo2

just different specs of car 1 is basic 2 has elc windows and CD player maybe something Else and 3 has it all

My Fusion 2 (2003) does not have Fog lights fitted and I was wondering if there is a connector in the engine bay to facilitate the installation of Foglights.I found on connector with a pair of wires in it ix Black and 1x Green/Blue it is mounted close to the windscreen washer reservoir.Thanks in anticipation of a reply.NTech.

this is the wire for the front fogs

hi all thanks for your input i dint get any details from here other than here name and phone number and reg
the fact that she dint report the claim until 3 hrs later will this go in my favorer  i have reported it to the police and the might look into finding my wittiness
i hope while i was on the phone to the insurance they put me on hold and spoke to here and shes saying that i was speeding and that here maneuver was complete and that she dints see me ummmmmmm  if she dint see me how she know if i was speeding and why pull out

you can open it from underneath the car theres loads of room to get to the catch

In relation to the problem with the wipers on slow speed I have not had this problem with my Fusion but a previous car did.Did you try the wipers with the blades lifted off the windscreen?.My problem with my previous car was the 3 finger contacts in the wiper rotor assembly,the grease the manufacturers applied had dried out and when the wipers came under pressure ie at mid way on the sweep the pins could not ride over the small build up of hard grease and stopped (when on fast speed the momentum was able to carry them over) I removed the wiper assembly and rotated it by connecting it to a 12V battery and used a small piece of plastic and a cloth soaked in methylated spirit to clean the tracks and then coated the track with electrical contact grease and it lasted for years before I sold the car on.I know it is a long shot but possibly worth a try. good luck Regards NTecH

thanks i will have a go at this weekend if its not rain ing
the wiper motor is bolted to the front shook if i unbolt this will the front shook drop to the ground or will it be OK