===PCM DTC P086B:1E-2F===
Code: P086B - Neutral Position Sensor 'A' Circuit Range/Performance

Additional Fault Symptom (:1E):
 - Circuit Resistance Out Of Range

Status (-2F):
 - DTC Present at Time of Request
 - Malfunction Indicator Lamp is Off for this DTC

Module: Powertrain Control Module

 Freeze Frame  #1:
-LOAD: 0.00 % - Calculated Load Value
-ECT: 21 °C - Engine coolant temperature
-RPM: 0 1/min - Engine Revolutions Per Minute
-FUELSYS: error  - Fuel System Status (Open/Closed Loop)
===END PCM DTC P086B:1E-2F===

===PCM DTC P08AE:00-2F===
Code: P08AE - Neutral Position Sensor 'B' Circuit Range/Performance

Status (-2F):
 - DTC Present at Time of Request
 - Malfunction Indicator Lamp is Off for this DTC

Module: Powertrain Control Module

 Freeze Frame  #1:
-LOAD: 0.00 % - Calculated Load Value
-ECT: 21 °C - Engine coolant temperature
-RPM: 0 1/min - Engine Revolutions Per Minute
-FUELSYS: error  - Fuel System Status (Open/Closed Loop)
===END PCM DTC P08AE:00-2F===

===PCM DTC P086D:00-2F===
Code: P086D - Neutral Position Sensor 'A' Circuit High

Status (-2F):
 - DTC Present at Time of Request
 - Malfunction Indicator Lamp is Off for this DTC

Module: Powertrain Control Module

 Freeze Frame  #1:
-LOAD: 0.00 % - Calculated Load Value
-ECT: 21 °C - Engine coolant temperature
-RPM: 0 1/min - Engine Revolutions Per Minute
-FUELSYS: error  - Fuel System Status (Open/Closed Loop)
===END PCM DTC P086D:00-2F===

===PCM DTC P08B0:00-2F===
Code: P08B0 - Neutral Position Sensor 'B' Circuit High

Status (-2F):
 - DTC Present at Time of Request
 - Malfunction Indicator Lamp is Off for this DTC

Module: Powertrain Control Module

 Freeze Frame  #1:
-LOAD: 0.00 % - Calculated Load Value
-ECT: 21 °C - Engine coolant temperature
-RPM: 0 1/min - Engine Revolutions Per Minute
-FUELSYS: error  - Fuel System Status (Open/Closed Loop)
===END PCM DTC P08B0:00-2F===

===PCM DTC P086B:38-2F===
Code: P086B - Neutral Position Sensor 'A' Circuit Range/Performance

Additional Fault Symptom (:38):
 - Signal Frequency Incorrect

Status (-2F):
 - DTC Present at Time of Request
 - Malfunction Indicator Lamp is Off for this DTC

Module: Powertrain Control Module

 Freeze Frame  #1:
-LOAD: 0.00 % - Calculated Load Value
-ECT: 21 °C - Engine coolant temperature
-RPM: 0 1/min - Engine Revolutions Per Minute
-FUELSYS: error  - Fuel System Status (Open/Closed Loop)
===END PCM DTC P086B:38-2F===

===PCM DTC P08AE:38-2F===
Code: P08AE - Neutral Position Sensor 'B' Circuit Range/Performance

Additional Fault Symptom (:38):
 - Signal Frequency Incorrect

Status (-2F):
 - DTC Present at Time of Request
 - Malfunction Indicator Lamp is Off for this DTC

Module: Powertrain Control Module

 Freeze Frame  #1:
-LOAD: 0.00 % - Calculated Load Value
-ECT: 21 °C - Engine coolant temperature
-RPM: 0 1/min - Engine Revolutions Per Minute
-FUELSYS: error  - Fuel System Status (Open/Closed Loop)
===END PCM DTC P08AE:38-2F===

===PCM DTC P086A:00-2F===
Code: P086A - Neutral Position Sensor 'A' Circuit / Open

Status (-2F):
 - DTC Present at Time of Request
 - Malfunction Indicator Lamp is Off for this DTC

Module: Powertrain Control Module

 Freeze Frame  #1:
-LOAD: 0.00 % - Calculated Load Value
-ECT: 21 °C - Engine coolant temperature
-RPM: 0 1/min - Engine Revolutions Per Minute
-FUELSYS: error  - Fuel System Status (Open/Closed Loop)
===END PCM DTC P086A:00-2F===

===PCM DTC P2123:22-2C===
Code: P2123 - Throttle/Pedal Position Sensor/Switch 'D' Circuit High

Additional Fault Symptom (:22):
 - Signal Amplitude Greater Than Maximum

Status (-2C):
 - DTC Maturing - Intermittent at Time of Request
 - Malfunction Indicator Lamp is Off for this DTC

Module: Powertrain Control Module

 Freeze Frame  #1:
-LOAD: 0.00 % - Calculated Load Value
-ECT: 20 °C - Engine coolant temperature
-RPM: 0 1/min - Engine Revolutions Per Minute
-FUELSYS: Open Loop  - Fuel System Status (Open/Closed Loop)
===END PCM DTC P2123:22-2C===

===PCM DTC P2122:21-2C===
Code: P2122 - Throttle/Pedal Position Sensor/Switch 'D' Circuit Low

Additional Fault Symptom (:21):
 - Signal Amplitude Less Than Minimum

Status (-2C):
 - DTC Maturing - Intermittent at Time of Request
 - Malfunction Indicator Lamp is Off for this DTC

Module: Powertrain Control Module

 Freeze Frame  #1:
-LOAD: 0.00 % - Calculated Load Value
-ECT: 20 °C - Engine coolant temperature
-RPM: 13 1/min - Engine Revolutions Per Minute
-FUELSYS: Open Loop  - Fuel System Status (Open/Closed Loop)
===END PCM DTC P2122:21-2C===

===PCM DTC P2138:00-2C===
Code: P2138 - Throttle/Pedal Position Sensor/Switch 'D'/'E' Voltage Correlation

Status (-2C):
 - DTC Maturing - Intermittent at Time of Request
 - Malfunction Indicator Lamp is Off for this DTC

Module: Powertrain Control Module

 Freeze Frame  #1:
-LOAD: 0.00 % - Calculated Load Value
-ECT: 20 °C - Engine coolant temperature
-RPM: 86 1/min - Engine Revolutions Per Minute
-FUELSYS: Open Loop  - Fuel System Status (Open/Closed Loop)
===END PCM DTC P2138:00-2C===

===OBDII DTC None===
Successful DTC reading, no error codes found

Module: On Board Diagnostic II

===END OBDII DTC None===

===APIM DTC None===
Successful DTC reading, no error codes found

Module: Accessory Protocol Interface Module

===END APIM DTC None===

===FCDIM DTC None===
Successful DTC reading, no error codes found

Module: Front Control/Display Interface Module

===END FCDIM DTC None===

===ABS DTC U0401:00-68===
Code: U0401 - Invalid Data Received from ECM/PCM A

Status (-68):
 - Previously Set DTC - Not Present at Time of Request
 - Malfunction Indicator Lamp is Off for this DTC
 - Test not complete

Module: Antilock braking system

 Freeze Frame  #1:
-EVENT_TIME: 302953218 s (Wed Jun 14 21:11:55 2023) - Event time
-TOTAL_DISTANCE: 141777 km - Total Distance
-MODULE_VOLTAGE: 11.8 V - Control Module Voltage
-OUTDOOR_TEMPERATURE: 17 °C - Outside temperature
-POWER_MODE: error  - Power Mode Status
-AYC: Inactive  - AYC
-ABS: Inactive  - ABS
-BTCS: Inactive  - BTCS -201D
-RSC: Inactive  - RSC
-BTC: Inactive  - BTC
-HDC: Inactive  - HDC
-BST_REL_SW: Inactive  - Booster Release Switch State
-VAC_BST_ST: Inactive  - Active Vacuum Booster State
-HYD_PMP_ST: Inactive  - Hydraulic Pump State
-ECU_POWER_SUPPLY: 11.1 V - ECU Power Supply Voltage
-VSS: 0.0 km/h - Vehicle Speed
===END ABS DTC U0401:00-68===

===RCM DTC None===
Successful DTC reading, no error codes found

Module: Restraint Control Module

===END RCM DTC None===

===PSCM DTC None===
Successful DTC reading, no error codes found

Module: Power Steering Control Module

===END PSCM DTC None===

===ACM DTC None===
Successful DTC reading, no error codes found

Module: Audio Control Module

===END ACM DTC None===

===IPC DTC None===
Successful DTC reading, no error codes found

Module: Instrument Panel Control Module

===END IPC DTC None===

===PDM DTC None===
Successful DTC reading, no error codes found

Module: Passengers Door Control Unit

===END PDM DTC None===

===DDM DTC None===
Successful DTC reading, no error codes found

Module: Drivers Door Module

===END DDM DTC None===

===HVAC DTC None===
Successful DTC reading, no error codes found

Module: Heating Ventilation Air Conditioning

===END HVAC DTC None===

===RFA DTC U0001:00-08===
Code: U0001 - High Speed CAN Communication Bus

Status (-08):
 - Previously Set DTC - Not Present at Time of Request
 - Malfunction Indicator Lamp is Off for this DTC

Module: Remote Function Actuator

===END RFA DTC U0001:00-08===

===BCMii DTC None===
Successful DTC reading, no error codes found

Module: Body Control Module

===END BCMii DTC None===

===GPSM DTC None===
Successful DTC reading, no error codes found

Module: Global Positioning System Module

===END GPSM DTC None===