Sign in to follow this  
F0CUE

Crank breather pipe

Recommended Posts

Does this look like it needs replaced or are these ones shaped like this at this end?

IMG_20190210_152427.jpg

Share this post


Link to post
Share on other sites
 

what engine is it? when I had mk1 focus 1600 it had a pipe that looked like that on front of engine that ran under the inlet manifold. I can't make out on your pic quite where it is. The car started having high tickover, the pipe looked like that and on the other side of it had split letting in air.  I never did replace it. I just wrapped a ton of good quality insulation  tape round it. Wasn't easy to get to. A bodge, not to save money, but because I wanted to fix it there and then and not wait for part/drive miles to get it.

Share this post


Link to post
Share on other sites

It's the 1.6 sigma/duratec. That is behind the inlet but the pictured part just sticks out near the alternator and the part below the straight part is the throttle body.

Share this post


Link to post
Share on other sites

Does anyone else have any opinion on it? I'm trying to track down whistling noises the intake is all right I've done the close off test and the engine nearly died so no leaks in there.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this