Jump to content
Do Not Sell My Personal Information


MK3 Front Bumper with sensor/washer cutouts


Recommended Posts

Hello all,

Long time reader, first time poster. I am having a little trouble sourcing a front bumper for my Focus estate. It is a Titanium X spec and came with factory fitted sensors/headlamp washers.

I had a little bump in the snow and need to replace the entire front bumper. I spoke to a few Ford garages who told me they were having problems getting the bumper as it comes sprayed direct from the factory. I have been looking online and whilst I could probably refit the plush fit sensors in the bodyshop, I wasn't too sure about the washer cutouts. I still have one of the covers and can buy another online so could perhaps just make suitable sized holes in any bumper and make good?

Incidentally I also noticed that the washers didn't actually work properly when I bought the car used. One stays popped out and the other leaks but I imagine it can't be a difficult fix.

The part number from TrustFord when they estimated repairs for the bumper was 1719349.

Any help or advice would be greatly appreciated. 

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Forums


News


Membership