Leoschariot Posted July 3, 2014 Share Posted July 3, 2014 HI When i engage my packing aid, all i get is a continuous beep. I have removed all rear sensors and cleaned but to no avail. There is no flashing light on the dash so I am a bit miffed?? Would anybody have any experience of same problem? Quote Link to comment Share on other sites More sharing options...
jeebowhite Posted July 4, 2014 Share Posted July 4, 2014 Did you disconnect all sensors then try it without? if so if its not changing then it sounds like the module is at fault. Quote Link to comment Share on other sites More sharing options...
Leoschariot Posted July 4, 2014 Author Share Posted July 4, 2014 I disconnected each one in turn , cleaned and replaced. I didn't activate the system without any or all of the sensors unplugged. Should I be trying that do you think? Also do you know where the module is, as I was told it's in the side panel in the boot but having opened that up, I cannot see it Quote Link to comment Share on other sites More sharing options...
jeebowhite Posted July 4, 2014 Share Posted July 4, 2014 yeah you should disconnect each in turn then start the system up that way if you unplug a bad one you can narrow it down, it could be just a bad wire. As for the panel, normally its behind the left hand side panel in the bottom most corner of the wing. Quote Link to comment Share on other sites More sharing options...
Leoschariot Posted July 4, 2014 Author Share Posted July 4, 2014 Thanks I'll give that a go then It's just that I read somewhere that if a sensor is disconnected, the system throws up a fault anyway. That's the reason I didn't do it originally the way you said. There always the option that it's one of the front sensors, but they look a bugger to remove! Quote Link to comment Share on other sites More sharing options...
747777 Posted July 4, 2014 Share Posted July 4, 2014 Remove the whole rear sub-loom and check for connector and wiring integrity. (known problem). The loom disconnects at the FS lower frame where it exits via a grommet. Quote Link to comment Share on other sites More sharing options...
137699 Posted July 7, 2014 Share Posted July 7, 2014 Check the front ones very carefully for bubbling paint. If any have paint blisters then that will be what's causing your issue. Quote Link to comment Share on other sites More sharing options...
Leoschariot Posted July 7, 2014 Author Share Posted July 7, 2014 I have a feeling it is the front causing the problem as all the back sensors seem to be pulsing as if they are working. Problem is the front ones are not as easy to get out I fear. Do I have to remove the wheel arch liner and or under tray? Also still have not managed to locate module... Sent from my iPhone using Ford OC mobile app Quote Link to comment Share on other sites More sharing options...
747777 Posted July 13, 2014 Share Posted July 13, 2014 The module is, I believe, behind the FS boot side access panel. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Ford UK Shop
Sponsored Ad
Name: eBay
Ford Model: FordUK Shop
Ford Year: 2024
Latest Deals
Ford UK Shop for genuine Ford parts & accessoriesDisclaimer: As the club is an eBay Partner, The club may be compensated if you make a purchase via the club
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.