Hi all.

Please help. I had an issue with a lower balljoint pinchbolt to replace me wishbones. long story short i replaced the hub coz the bolt wouldnt budge. Now the traction control light is on. got abs though. tried replacing abs sensors with no change.

cheers in advance.

Check fuses F11, F21 & F30

The fuses are in good working order. Im sure it cant be the hub bearing as the abs is working.

There's no easy answer does the hub have the sensor ring in it on the previous mk1 some did some didnt some required you use the one from the old hub ? Was it the correct hub? It may be a loose cable a damaged sensor or sensor ring youde need to go over the whole thing again which is what a garage will do if the lights on technically you shouldnt have abs ie the brake pedal pulsating when you brake in wet conditions you may need to get it diagnosed or have the fault codes read

Abs light is off. Got abs, Pedal pulsates on hard braking. Tc light on permanently. Stripping it down and starting again is one of those things that u no ull have to do but r reluctant to do lol. Dont wanna pay crazy money for a reading if im honest. My bluetooth jobby obviously aint up to the task. Back to the drawing board. Thanx for the replies.

Hi, take a look at this, it explains how it works, it could help you get yours right

http://auto.howstuffworks.com/28000-traction-control-explained.htm