Any 5 door owners out there sporting mountune side stripes?

Also, where did you get them from, other than DMB (still waiting a reply)

Post your pictues of your 5 doors here.

a thought you had mountune stripes?

On the old car but didn't fit properly / too short.

I've asked DMB about another set but no reply yet.

yeah see what you mean mate let me know how ye get on

Got a quote yesterday from a firm that holds the licence to make these and quoted me £115 which was ridiculous but that was without VAT :o

Any ST owners with these stripes? Post up a picture.

Fek that!

Got a quote yesterday from a firm that holds the licence to make these and quoted me £115 which was ridiculous but that was without VAT :o

Any ST owners with these stripes? Post up a picture.

Was that Joyce designs, tests who makes the Mountune stripes.

I was just downloading some of your pictures off another site Mark :d

Yeah it was Joyce design. Very helpful but not paying that when mountune are cheaper.

Can you measure your stropes for me Mark along the top and bottom please.

Definitely a difference in length. My picture has the stripes masking taped on so looks like its too far forward.

If you can wait till tomorrow then yes, lol. Bottom edge and from front of door to top of stripe before rear wheel arch?

You should be able to increase the gaps in the rear section slightly to suit.

Bottom to Bottom / Top to Top if possible Mark.

I don't have the stripes now but reckon they were 4 inches / 10cm too short.

I'm gunna use the measurements and get onto DMB again.

We're they genuine Mountune stripes or made by DMB with a Mountune logo?

Other DMB strioes I seen have all looked like the are too short, as if they've stooped short to avoid the stripe looking distorted where the arch starts to flare out.

And yes I'll measure them tomorrow.

DMB mate. I queried it and was told that's how they come. This was about a year ago now.

Thanks for doing that :)

When I mentioned how much I'd paid for the stripe to the guy fitting it, he said that the price was about righ because of the material and the time making a template, they must be cut in such a way that the appear to be straight even on curved bodywork.

Bottom to Bottom / Top to Top if possible Mark.

I don't have the stripes now but reckon they were 4 inches / 10cm too short.

I'm gunna use the measurements and get onto DMB again.

Along the bottom edge is 1655mm

Along the top edge is 1690mm ( from the top of the tapered section to the back)

Tapered section is 50mm

Thanks Mark. I'll get onto Dave at DMB tomorrow.

Sorry Mark. Dave at DMB wants to know where you measured the top from. Thanks

Done. DMB have saved the day again :)