jdw66 Posted September 12, 2009 Share Posted September 12, 2009 Any ideas what this points to ? all i know is it is turbo boost system performance,Turbo? car is now in limp mode i have a obd reader this is how i got the code but i dont want to erase it so i can show mechanic if need be.Thanks Quote Link to comment Share on other sites More sharing options...
mintalkin Posted September 12, 2009 Share Posted September 12, 2009 the two common faults for this code is the egr valve is stuck open. you can remove and clean this -http://fordwiki.co.uk/index.php/Main_Page ( check out the egr valve clean under the mondeo section) or the electronic turbo actuator return arm is siezed due to a build up of carbon on the turbo vanes, you can check this by seeing if you can move the little arm by hand when you remove the clip on the arm. but this is unlikely unless you have mega miles on the car. i would try the egr first. Quote Link to comment Share on other sites More sharing options...
jdw66 Posted September 12, 2009 Author Share Posted September 12, 2009 I had the egr and inlet manifold off a few weeks ago and gave them a good cleaning still had juddering and seemed to still be smoking,do you think it could be split in boost pipe from egr to intercooler?. Only 72k with full service history how easy is it to look actuater arm?.Could i have a faulty egr valve? Quote Link to comment Share on other sites More sharing options...
mintalkin Posted September 13, 2009 Share Posted September 13, 2009 juddering at around 1800rpm and black smoke are symptons of a split intercooler pipe. Quote Link to comment Share on other sites More sharing options...
jdw66 Posted September 14, 2009 Author Share Posted September 14, 2009 Your were spot on mate intercooler pipe had a 3 inch split relaced it still smoking but no judders hopefully it will clear after a good run out.Thanks again all !!!!! Quote Link to comment Share on other sites More sharing options...
Simon whirlwind Posted August 25, 2014 Share Posted August 25, 2014 Hi there, I have a problem with the car going into limp mode, and the engine management light coming on (occasionally). The code reader shows 2263 (turbo boost issue). I have replaced the stainless steel pipe to the EGR valve, had the valve cleaned out and I have now blanked it off. I start the car in the mornings, and the car runs perfect, no juddering, loss of power, or anything. I stop the car for less than 2 hours and I get the dreaded limp mode. If I leave the car for more than around 3 hours, now problem on starting and driving. I have read on posts that a turbo hose could be leaking, although I can't see that as I have no loss of power at all. I have read that the MAS sensor could need cleaning. I have also seen that there is a vacuum thing between the MAS and the EGR valve, I assume it is a boost sensor valve as it has three pipes going into it. between the EGR valve, the turbo actuator and some where else? Can anyone give me any tips on how to resolve this problem, very frustrating as I thought I had cured this by blanking off the EGR valve. The car ran perfectly for 4 days without limp mode, which made me think it was all sorted? Thanks in advance for your help xxxx Quote Link to comment Share on other sites More sharing options...
jeebowhite Posted September 1, 2014 Share Posted September 1, 2014 You wont feel a massive drop in performance on the car if you have a split pipe or hose. I would be starting the engine and getting someone to give it a few revs whilst feeling around the intercooler pipe for any leaking air. Quote Link to comment Share on other sites More sharing options...
haighie Posted October 23, 2014 Share Posted October 23, 2014 Hi I had the same problem lots of juddering and hesitation also fault code p2263 my turbo pipe had split the 90 degree bend one I've changed that I also blanked the egr valve off as well massive improvement now I'm getting a whistle when the turbo is spoiling up and down no loss of power at all but I don't notice smoke through the day but a hell of a lot at night even when turbo hasn't kicked in any surgeations Sent from my iPhone using Ford OC Quote Link to comment Share on other sites More sharing options...
Simon whirlwind Posted October 23, 2014 Share Posted October 23, 2014 Hi I had the same problem lots of juddering and hesitation also fault code p2263 my turbo pipe had split the 90 degree bend one I've changed that I also blanked the egr valve off as well massive improvement now I'm getting a whistle when the turbo is spoiling up and down no loss of power at all but I don't notice smoke through the day but a hell of a lot at night even when turbo hasn't kicked in any surgeations Sent from my iPhone using Ford OC Quote Link to comment Share on other sites More sharing options...
Simon whirlwind Posted October 23, 2014 Share Posted October 23, 2014 I also found a slit in the rubber intercooler/egr valve hose. Was a horrible hub trying to fit the bottom of the hose onto the intercooler pipe, but got there in the end. Car runs really well now, but also smokes a bit when I give it some revs through the gears. Not really bothered me too much though as I'm just glad I finally got to the bottom of this ongoing problem. I reckon it is worth while giving it a good Grady from time to time, as this seems to give the turbo vanes a good dechoke.too much town driving causes these problems with the vanes. Even long journeys I don't think clear the vanes properly. A ggood frash I would say works. Quote Link to comment Share on other sites More sharing options...
haighie Posted October 23, 2014 Share Posted October 23, 2014 I will have to have a look it's just smoking when not even giving it any that's the problem Sent from my iPhone using Ford OC Quote Link to comment Share on other sites More sharing options...
jeebowhite Posted October 23, 2014 Share Posted October 23, 2014 Smoking could be egr to be honest did you replace the egr valve hose? Quote Link to comment Share on other sites More sharing options...
haighie Posted October 23, 2014 Share Posted October 23, 2014 No I blanked it mate Sent from my iPhone using Ford OC Quote Link to comment Share on other sites More sharing options...
jeebowhite Posted October 23, 2014 Share Posted October 23, 2014 The egr vacuum hose I believe is separate to the egr pipe your referring to if I'm not mistake Quote Link to comment Share on other sites More sharing options...
haighie Posted October 23, 2014 Share Posted October 23, 2014 Not sure mate I will have to have a look at it Sent from my iPhone using Ford OC Quote Link to comment Share on other sites More sharing options...
Gefro71 Posted February 9, 2021 Share Posted February 9, 2021 Had the p2263 on my 2008 mondeo tdci looked on many forums at the fault mine turned out to be the mas sensor simple fix and only 30 quid car running alot better and mpg has gone up to a respectful figure. Quote Link to comment Share on other sites More sharing options...
nicam49 Posted February 9, 2021 Share Posted February 9, 2021 Do you mean MAP or MAF sensor? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Ford UK Shop
Sponsored Ad
Name: eBay
Ford Model: FordUK Shop
Ford Year: 2024
Latest Deals
Ford UK Shop for genuine Ford parts & accessoriesDisclaimer: As the club is an eBay Partner, The club may be compensated if you make a purchase via the club
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.