• Announcements

    • Stoney871

      Posting in General Chat thread.   11/11/2017

      it has been noted that too many Members are posting messages in the General Chat area instead of the correct Forums. Any messages posted in the General Chat area that are not General Chat will be deleted without warning and offenders may recieve warning points if repeated instances are seen from that Member. There are plenty of different Club areas that encompass 99% of Ford related posts, please select and use the correct one. If anyone is not sure of which area to post something then feel free to P/M myself or other Senior Staff for guidance. The Moderating Staff are having to spend far too much time chasing this problem instead of maintaining the other areas of the forum.


Budding Enthusiast
  • Content count

  • Joined

  • Last visited

About Stumax

  • Rank

Profile Information

  • Ford Model
  1. Hi stumax

    i am having the same problem, front wipers not working and I have a message on the dash board stating " Alarm service required" I located the horn sound unit under the passenger wheel arch but I couldn't unplug the unit, I stuck my arm up there as I can get to it but it doesn't seem to pull out. I don't want to use pliers and risk damage. You may know how to unplug it, as I read that you have managed to pull it out. How does this unplug? Is it a simple pull out or are there lugs to undo, I cannot feel any lugs. My car is an s-max 59 plate. Appreciate any help. Thanks 

  2. smax official trouble topic

    Hello Jezzer, Good news...I'm glad my notes & experiances are being of use to someone. The bad news is.. 1. In the short term the only way i could reactivate the front wippers was to un plug the alarm sounder module located in the wheel arch. Bit tricky as I found the only way was to unbolt the whole thing as to be able to see how the wiring cable was snap fitted in to the sounder unit itself. 2. Once water ingress has taken place its unlikley that drying out will recover the problem as the damage has been done to the PCB and its mounted electronic components, you could see the surface mount resistors on my unit had virtually been burnt off the board. 3. It cost me £250 at a Ford dealer to replace a new unit and reset the alarm fault display on the dashboard etc. 4. Im awaiting a reply from Ford, Im not holding my breath, howver I've had some serious advice that Im not likley to get any thing. I'll keep this forum posted with any update. You never know perhaps thos really helpfull Ford people might read our remarks..
  3. smax official trouble topic

    I’m new to this forum group but have to also share my Smax faulty alarm system saga... The alarm sounded, hazard lights were activated and wipers stopped working all while the car was being driven in heavy rain conditions on a very busy a road during the rush hour on a Friday night. Whilst being driven by wife with our children in the vehicle...it doesn’t get much worse than this! The wife had to perform a rapid exit off the road whilst other road user thought she was trying to warn of a pending road accident due to the hazard light flashing Turning off the ignition, locking the car stopped the alarm...albeit from the lay-by whilst getting wet! Yes it is all down to the Alarm Horn Sounder unit in the near side front wheel arch. The module is hidden out of view by the plastic inner wheel arch liner. The module is bolted to bracket just behind the suspension strut, very close to the horozontal bulk head pressing. The bulk head has a drain hole in it to allow any rain water to be released. The hole is fitted with a plastic diverter tube...but the fit of the diverter tube is not good and any water drips off the drain tube and on the alarm module and or its connecting wiring loom. The modules purpose is sound an internal alarm horn if the vehicle is broken into, within the module it is supported by it own rechargeable battery backup, this is ensure the alarm will still sound if the main vehicle battery is removed or disconnected. This module is manufactured by Delphi for Ford the same component is fitted to Freelander II. Once the alarm horn sounder module is damp it is likely to breakdown. The breakdown is due to the electronics within the module shorting out, this will cause permanent damage. Root cause effects are varied from making false alarm sound, activating the hazard lights and sending a false signal to the wiper control module that demobilises the front windscreen function. If you’re wondering why I’m so sure of these facts it’s because I took out the wheel arch liner and unplugged the module and then the wipers worked fine. I then dismantled the module to see the PCB and its tiny surface mount components burnt with signs water stains! Although Ford MoCo stock standard answer is that they are not responsible for water ingress, I have to totally disagree; I'm in no way responsible for the design of this poor system. The Failure Mode is very dangerous and warrants safety recall and proven corrective measures implemented. I have complained to Mr Andy Barratt Customer Services Director at Ford, I will post his response as soon as it arrives, I’m hopeful of a refund of my £200 bill I got for this problem. Annoying as my car has only covered 28k miles. In the mean time I’m preparing a 'safety defect report to VOSA, I recommend that all other owners with this fault do the same to force some action, see link below for the form. http://www.vosa.gov.uk/vosa/repository/vehicle%20safety%20defect%20report.doc Also I will contact my local trading standards office as this is a safety issue.