Just repaired my Durashift gearbox actuator using the procedure in the superb posting by Lasse1955:
Starting a new post mainly because I somehow missed Lasse’s post two years ago when I forked out the thick end of a grand to have Ford dealer diagnose and replace Durashit (OOPs, genuine typo, but maybe it ought to stay uncorrected!). His post is the place to go but hopefully this will help point the way there. I just have a few minor points to make
First, from all I’ve now read, the gearbox actuator problem diagnosed and sorted by Lasse ought to be the prime suspect if you have a Durashift failure that you can’t otherwise specify. Mine failed(nothing on gear selection display, warning light, no engine start) after just two years and 10K miles from installing a new unit. I only took off the actuator unit to eliminate from enquiries, as they say. It was stuck solid. Needed levering forcibly with a big screwdriver to release the rack.
Getting the unit off the car involves just four Torx bolts. The top one is a fiend to get at, or even see without a mirror, but undo it first, not last, otherwise it’s even more tricky with the weight of the unit hanging on it. Otherwise, easy to reach the other bolts if you raise the car just a bit to get under with usual precautions.
I’d really recommend forking out a tenner for a 16mm reameron Ebay. http://www.ebay.co.uk/itm/Hand-Reamer-16mm-HSS-Milling-/121206449964?ssPageName=ADME:L:OC:GB:3160
It might not be a top end tool but easily good enough to use on plastic.
I went in from the bottom end with the reamer (the bottom end when unit on the car) on the basis that it might give better alignment/guidance of the tool.
When re-assembling, you need to reset the rack with cogs in the right position. As it now moves
freely in the sleeve/bush, it’s an idea to use adhesive tape or similar to hold the rack in place while fitting the gear to it.
Might get back with photos if I can sort temporary blip with technology