• Announcements

    • Stoney871

      Posting in General Chat thread.   11/11/2017

      it has been noted that too many Members are posting messages in the General Chat area instead of the correct Forums. Any messages posted in the General Chat area that are not General Chat will be deleted without warning and offenders may recieve warning points if repeated instances are seen from that Member. There are plenty of different Club areas that encompass 99% of Ford related posts, please select and use the correct one. If anyone is not sure of which area to post something then feel free to P/M myself or other Senior Staff for guidance. The Moderating Staff are having to spend far too much time chasing this problem instead of maintaining the other areas of the forum.


Budding Enthusiast
  • Content count

  • Joined

  • Last visited

About saabu

  • Rank

Contact Methods

  • First Name

Profile Information

  • Gender*
  • Ford Model
  • Ford Year
  • UK/Ireland Location
  1. Fixing Rear Sensors

    Thanks again. Sid
  2. Fixing Rear Sensors

    Thanks for your prompt reply. I shall have a look under the wing on the offside, as you suggested and see if there is a grommit. Feel a bit hesitant to drill a hole into the chassis though. I presume that I would not need to remove the bumper to do this job. Regards, Sid
  3. Dear friends, I would appreciate your input regarding the following two queries I have. My car is a Ford Mondeo 2002 LX Auto. I have decided to install some rear sensors to help with parking. These need to be drilled into the bumper. I have already bought the item. My queries are as follows: 1. How do I feed the wire from the sensor [4 in number] into the boot. I cannot see any obvious openings in the chassis through which I can feed the wires through. 2. How do I identify which is the wire for the reverse light on the light module [needed to fix the wire to sensor box to power up] Look forward to hearing from you and thanking you in anticipation of the same. Best regards