• Announcements

    • Stoney871

      Posting in General Chat thread.   11/11/2017

      it has been noted that too many Members are posting messages in the General Chat area instead of the correct Forums. Any messages posted in the General Chat area that are not General Chat will be deleted without warning and offenders may recieve warning points if repeated instances are seen from that Member. There are plenty of different Club areas that encompass 99% of Ford related posts, please select and use the correct one. If anyone is not sure of which area to post something then feel free to P/M myself or other Senior Staff for guidance. The Moderating Staff are having to spend far too much time chasing this problem instead of maintaining the other areas of the forum.


Budding Enthusiast
  • Content count

  • Joined

  • Last visited

About tompablomontoya

  • Rank

Profile Information

  • Ford Model
  1. Blowers but no heat!

    Thank you for your help, I managed to have a look in daylight for the first time today, I know exactly why the fan is kicking in; water is leaking directly out of the pipe in the picture shown, at present I have no idea what should be in it's place! I have checked fuses, nothing appears to have burnt out. Do you know what should be where the hose ends?!
  2. Blowers but no heat!

    The difference with this problem is that I know precisely what caused it! My Focus has sat on my drive for between 5 and 7 days, and with the big freeze in the UK at the moment, various pipes have frozen to an extent (not enough anti-freeze). When I turned the ignition over this morning, the blowers were still set to 3 or 4 from the previous time I had used the car, and after a good 20 seconds, there was a haze in the car and the smell of melting plastic or fuses! (hard to tell). I immediately turned the blowers off and then engine off, before trying again - this time the engine made a rather loud screeching noise so I didn't persist. I topped up the anti-freeze, left it to work through the system, and after an hour, everything was fine. The only problem that still exists is my blowers do not pump out any heat on any setting, there is still the faint smell of something melting, and after a 10 minute journey, the engine fan kicks in. There are no other electrical problems as far as I can tell. I have searching various forums and websites to try and find answers, it appears that it could be a poor electrical contact of the connector on the blower motor control switch (or it's burnt out!). If it is this, what are the implications? i.e. is it easy to replace? And if it is not this, what else might it be?! Cheers