Search the Community
Showing results for tags '10 sub enclosure'.
Found 1 result
Lenny posted a topic in Ford Focus ClubStarted out with a plan to install one of these custom fit 10"sub enclosures See link: http://www.ebay.co.uk/itm/Ford-Focus-Mk2-Custom-Fit-MDF-10-Sub-Box-Subwoofer-Enclosure-Bass-/360623710681?pt=UK_In_Car_Technology&hash=item53f6d921d9 There worth every penny very well built and perfect fit, Only problem was where to fit the AMP to drive the 10" sub within the enclosure, I've created two ideas both of similar design, I will now explain: After fitting the custom sub enclosure i measured the gap between the enclosure and back of rear seat: Measures 35mm free space :) I then measured the gap between the wheel arch and the back of rear seat when closed, Measures 15mm :) So i then purchased a sheet of 9mm MDF Folded down the rear seats and measured the length between the wheel arches Measures 1045mm :) I then cut the sheet to the correct width to fit inside the arches 1045mm An additional cut out is required along the bottom to allow the seat bracket sit in to the MDF panel Next i cut two slips measuring 25mm wide and 405mm long, The height of the main sheet has also been cut down to 405mm so as not to obstruct the seat retaining brackets These fit in between the wheel arches and the back of the rear seat as saw in images aswell as providing mounting surface for the 1045mm sheet: Now since there's 35mm depth available I added an extra slip of 9mm mdf around the three sides of the 1045mm sheet, Resulting in a triple layer edge and internal cavity of 18mm between the back of rear seat and the main sheet of MDF The internal cavity is purposly designed to house the relevant cables required for the amp or amps, The plan is to surface mount the amp inside the boot on the 9mm sheet, Drill corresponding holes for cables to pass through the sheet in to the amp at required locations this minimising the visibility of cables, Once completely marked out and drilled, The sheet will be wrapped in carpet matching that of the boot interior resulting in a professional finish with no visible cables. I chose to create a full width panel as my install involves installing two amps here's my specific plan: Purchased some paint to seal the MDF aswell as providing a rough surface for bonding the carpet. Sprayed two coats on the rear and one on the front Later Acquired some EvoStik Aerosol glue adhesive and a roll of AutoLeads acoustic carpet. There's plenty of carpet in one roll capable of covering two panels I cut the carpet to generous size, Sprayed glue on to carpet and panel then pressed both together; smoothing out the wrinkles Now fitted to the car the carpet is a perfect match to the existing factory finish ready for mounting amp while keeping cables hidden inside the cavity. Prior to fitting amplifier to the panel I purchased some aluminium bushings to use as washers Creating a gap between the amplifier and carpet for air to circulate cooling the amplifier Sat amplifier face down on inside of panel to mark out the corresponding holes Drilled out markings Amplifier now mounted in position with all cables terminated at the rear of the panel Mono amplifier, 1 fared capacitor and 10" sub enclosure added. Still enough space for a buggy 👍 Thanks for viewing and hope this helps