Posting in General Chat thread. 11/11/2017it has been noted that too many Members are posting messages in the General Chat area instead of the correct Forums. Any messages posted in the General Chat area that are not General Chat will be deleted without warning and offenders may recieve warning points if repeated instances are seen from that Member. There are plenty of different Club areas that encompass 99% of Ford related posts, please select and use the correct one. If anyone is not sure of which area to post something then feel free to P/M myself or other Senior Staff for guidance. The Moderating Staff are having to spend far too much time chasing this problem instead of maintaining the other areas of the forum.
Search the Community
Showing results for tags 'locking pin'.
Found 1 result
Hello everyone; posted a while back about some engine rattling (turned out to be exhaust bracket) and got some useful advice. Thought i'd come back for some more thoughts on a maintenance question i have :) . I have been diagnosed with a worn oil pump. I thought i would have a go at swapping this out myself; got the new pump in hand and have so far removed sump, oil pickup, auxilliary drive belt, crankshaft pulley and cambelt covers. The question i have relates to how it is possible to maintain engine timing while removing the crankshaft sprocket which is also used to fix the crankshaft timing via a locking pin (drill bit). My Haynes manual makes an incredibly brief reference to locking the flyheel in the correct position for engine timing, which sounds sensible. However, the manual only discusses elswhere, the method of locking - locking the flywheel with a flywheel pin through the bell housing, while also saying that this cannot be used for engine timing purposes. This seemed a little ambiguous to me. The question i have is - how can i maintain engine timing if i cannot lock the flywheel with this 'non-timing' pin? Do i need to go so far as removing the starter motor and using a special tool to lock flywheel in correct timing or....(and this maybe a little risky).. can i do something a little simpler and mark the timing belt, fuel pump, crankshaft and camshaft sprockets with typex (is there a risk that residual engine pressure or camshaft forces will move engine parts dangerously if they are not secured? ...and i thought i could just pop the bonnet, undo a couple of bolts and be done by lunch... :D Thanks in advance :)