• Announcements

    • Stoney871

      Posting in General Chat thread.   11/11/2017

      it has been noted that too many Members are posting messages in the General Chat area instead of the correct Forums. Any messages posted in the General Chat area that are not General Chat will be deleted without warning and offenders may recieve warning points if repeated instances are seen from that Member. There are plenty of different Club areas that encompass 99% of Ford related posts, please select and use the correct one. If anyone is not sure of which area to post something then feel free to P/M myself or other Senior Staff for guidance. The Moderating Staff are having to spend far too much time chasing this problem instead of maintaining the other areas of the forum.

Sign in to follow this  

Guide Additional 12V Power Socket In Boot Focus Mk2.5

On the right hand side of the boot compartment on the Mk2.5 Focus and possibly the mk2 also,

their is an orange plug which is a positive feed for a 12v power socket,

the only additional items required to connect is a earth cable and a 12v socket,

attach a female spade connector to the earth feed and push it in to the slot next to the positive feed,

then push the orange connector on to the rear of the 12v power socket,

finally choose a location on the panel you would like to mount the socket and drill the hole.

their is power already being fed to the orange plug so their is no further wiring required.

I Purchased Ford 12v Power supply kit Finis Code: 1021887

it contained the 12v plug and cap

4metres of positive cable which i didnt need to use for fitting,

1 metre earth cable with female blade connector and ring terminal attached,

and 8 cable ties which i didnt need to use.

but this orange plug will work with any 12v socket that has 2 pins on the rear like this one found on ebay






I have crimped a ring terminal on to the opposite end of the earth feed cable,

and put it on to the screw that holds the panel in place like a washer then screwed the panel back in to place,

i now need to purchase a holesaw bit to fit the diameter of the 12v socket.


When finished

and the panels are back in place,

take care to ensure the rubber boot seal over laps the plastic interior around the boot opening, to avoid any leaks.





 Report this tutorial


There are no comments to display.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now