Want to remove the headlights to polish them up on the bench to remove the fogging from the plastic and take out some borken glass from an exploded bulb.

Have removed the top bolt and the protection round the wheel arches to get access but i cant see any other bolts - is this going to have to be a bumper removal job and ramp job  just to get the headlamp out?
 

3 screws?

 

 

Headlamp Assembly — 1.6L (321150)
 

Removal

    1.    Raise the vehicle. For additional information, refer to «Section 100-02».

µ    2.    Remove the wheelhouse trim panel front bolts.

µ    3.    Remove the wheelhouse trim panel rear bolts.

µ    4.    Remove the wheelhouse trim panel.

µ    5.    Detach the fender from the sill panel.

µ    6.    Remove the fender front clamp bolt.

µ    7.    Remove the fender rear clamp bolt.

µ    8.    Remove the headlamp lower screw.

    9.    Lower the vehicle.

µ    10.    Detach the bumper from the radiator grille opening panel.

µ    11.    Detach the fender from the wheelhouse.

µ    12.    Pull the bumper towards the front secure it to one side.

µ    13.    Remove the headlamp upper screws.

µ    14.    Disconnect the turn signal connector.

µ    15.    Remove the headlamp assembly.
 
l        Disconnect the headlamp connector.