Hi Folks. I need to remove the bumper cover from my 2017 Edge. I’ve removed what screws I can see on the underside, and around the wheel arch liner. I expect there to be a further myriad of plastic clips etc, which I can’t see.  Does anyone know of any good instructions out there, that will help me out? Many thanks, Karl.

Not sure if the Vignale, Sport/ST-Line and Titanium/Zetec have the same fixings due to the different trim options, but do these help Karl? ...

Rear Bumper Cover Dis and Assembly.pdfRear Bumper RI.pdfRear Bumper Cover RI.pdf

4 hours ago, Karl G said:

Hi Folks. I need to remove the bumper cover from my 2017 Edge. I’ve removed what screws I can see on the underside, and around the wheel arch liner. I expect there to be a further myriad of plastic clips etc, which I can’t see.  Does anyone know of any good instructions out there, that will help me out? Many thanks, Karl.

Hi Karl the obvious hex bolts to both arches and 3 underneath mid section once all the are removed at the top of the arches and below the rear lights pull the bumper outward ( a light tug should do it) then the whole bumper pulls back ward and drops off the rear frame. reversal is the same lift push back then rebolt.

Hi Karl the obvious hex bolts to both arches and 3 underneath mid section once all the are removed at the top of the arches and below the rear lights pull the bumper outward ( a light tug should do it) then the whole bumper pulls back ward and drops off the rear frame. reversal is the same lift push back then rebolt.