Jump to content
Do Not Sell My Personal Information


Focus Spring Replacement


mal165
 Share

Recommended Posts

Hi, I am in th eprocess of replacing the front spring on my focus titanium 2009, about to re-assemble but didn't notice the orientation of the top flange and I'm wondering if there is an alignment mark on the top mounting flange which should be lined up in a certain position relative to the strut/ bottom flange.

thanks in anticipation of your advice.

Link to comment
Share on other sites


From what I can remember it's symmetrical so won't matter what way it goes back. You will soon find out when you look at the bolt holes in relation to the mount

Link to comment
Share on other sites

Hi, Thanks for the prompt reply. I've just had a look at the suspension. there is a coloured paint mark on the flange and the part helical section underneath has a large 'protuberance' which is perhaps an alignment point. i'm usually careful in noting these things but it was bucketing down when the job was underway!

Link to comment
Share on other sites

did you replace in pairs as recommended

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share




×
×
  • Create New...

Forums


News


Membership