Okay, what black art do I have to learn to remove theses wiring pins from the block?

i need to remove one and reseat it in another block.

 

TIA 

It's most likely there's a 'barb' on the contact that needs to be depressed to release it. The manufacturers probably offer a special tool for the purpose but it's often possible to use a small slim screwdriver blade to do it. If you had access to a new contact it would show you where you need to go but if not it'll be trial and error. Either way it'll need to be released from the back of the moulding.

23 minutes ago, mjt said:

It's most likely there's a 'barb' on the contact that needs to be depressed to release it. The manufacturers probably offer a special tool for the purpose but it's often possible to use a small slim screwdriver blade to do it. If you had access to a new contact it would show you where you need to go but if not it'll be trial and error. Either way it'll need to be released from the back of the moulding.

Thank you, I bought pin removal tools from Amazon. So in theory I would need to feel my my way from the cable end and not the red end?

Aint I getting all technical lol 

1 hour ago, h1ghlander77 said:

I bought pin removal tools from Amazon.

I bought a set of these, but have more success with a needle or pin. The red piece of plastic needs to come out the end of the connection first and then the pin goes in where the red piece was to prise back the plastic clip holding the connection pin in.

1 hour ago, Nathan Buffery said:

I bought a set of these, but have more success with a needle or pin. The red piece of plastic needs to come out the end of the connection first and then the pin goes in where the red piece was to prise back the plastic clip holding the connection pin in.

Fantastic thank you Nathan. Much appreciated.