!Guide! Replacing The Left Transmission Mount - MK7 2011

----------------------------------------------------------

-Ford Fiesta Zetec JA8 1.25 duratec 16v petrol 08-13

----------------------------------------------------------

Misc:
-You should ideally replace the transmission mount bolts
-If you remove 2 or more engine/transmission mounts at a time then the outline of each mount needs to be marked with a pen. This is to regain correct alignment.
-If you are only removing 1 engine/transmission mount then it will naturally square itself off on reassembly
-Part number: 1536197

----------------------------------------------------------

-Put the front end on axle stands
-Jack up the transmission by a few millimetres (Use a block of wood so that you do not damage the transmission)

-Unbolt the 10mm negative battery terminal 
-Unbolt the 10mm positive battery terminal 
-Unbolt the 2 10mm battery clamp bar
-Remove the battery
-Unbolt the 3 10mm battery tray bolts (Spray them with penetrating oil and wire brush them first)
-Unbolt the 3 T30 torx bolts that secure the ECU to the battery tray
-Remove the battery tray
-Remove 8 10mm nuts on the metal bracket that the battery tray sits on & remove the bracket (Spray them with penetrating oil and wire brush them first)
-Move the ECU to one side

-Spray penetrating oil & wire brush the nuts & bolts on the transmission mount

-Remove the 2 18mm bolts securing the transmission mount arm to the transmission bracket
-Remove the 2 15mm bolts securing the transmission mount to the inner wing panel

-Replace the transmission mount
-Fasten the 2 15mm bolts to secure the mount to the inner wing panel @ 80Nm (Ideally replace the bolts)
-Fasten the 2 18mm nuts to secure the transmission mount arm to the transmission bracket @ 80Nm (Ideally replace the nuts)

-Fasten down the metal battery tray bracket with the 8 10mm nuts @ 30Nm
-Put the battery tray back in
-Fasten the ECU to the battery tray 3 T30 torx bolts
-Fasten the battery tray back down 3 10mm bolts & 30Nm
-Put the battery back in
-Refasten the 10mm negative battery terminal @ 25Nm
-Refasten the 10mm positive battery terminal @ 25Nm
-Fasten the battery clamp bar in place 2 10mm nuts @25Nm

-Lower the engine back down
-Lower the car back to the ground

----------------------------------------------------------

Useful sources:

Fiesta ST TTR Upper Motor & Transmission Mount Install

----------------------------------------------------------