Finally received my badge light for rear of car. So this morning in the freezing cold wind I decided to go and fit it.

I followed the guide from pree on here so thanks pree. However I didn't have a socket set long enough to undo the bolts to remove the trim so instead drilled a small hole to feed the wires into the boot behind the badge and filled it well with clear silicone to prevent any water getting through. Overall it took just over an hour start to finish and below is the finished project now it has turned dark. I absolutely love how it looks hope you do too.

This is how it was advertised

This is how it looks on my motor

Lee

Looking good!

That looks fantastic fella!

Looks nice :)

looks sweet fella, now you need door projectors ;)

Looks great Lee :)

Welcome to the glowing badge club :d

Lee where did you buy it from?

And where in Sheffield are you fella?

I'm from Shiregreen.

Looking good mate, I've got all the kit for this, just finding the time.

Wow, didn't used to be a huge fan of these, but it looks brilliant. Tempted now!

looks sweet fella, now you need door projectors ;)

Haha Yea I looked at some but don't know if I can be bothered fitting them lol

Lee

Lee where did you buy it from?

And where in Sheffield are you fella?

I'm from Shiregreen.

I'm from shire green too haha Lane top end.

Lee

Sorry got them from eBay. Only about 20quid I think. Will find the link when I get a min

Lee

Jesus you're 5 mins from me dude.

I'm just off Shiregreen lane

wow... Just over an hour for that job in the cold! mate, either your wiley cayote in disguise or I read far too much into Paul's guide and made it feel like much more work!