Is there anyway of putting a focus st exhaust on a 1.4 studio without cutting the wheel well away

Is there anyway of putting a focus st exhaust on a 1.4 studio without cutting the wheel well away

Hi,

No only option is to fit a duplex exhaust pipe, bends under the tyre well and out the other side, if the split is perfected

then equal puffs of steam will exit at same time on both pipes

It is possible but the ST exhaust must be modified to fit under the wheel well. To do this you have to cut the exhaust tips and weld them back on in a different angle to fit to the bumper. Because the ST exhaust must be mounted at a lower position to fit under the wheel well the exhaust can be seen from the rear which in my opinion does not look nice.

In my opinion it would be a lot easier and better looking to make a custom stainless steel dual exhaust system.

Thanks for the replie lads think will just find a normal exhaust save all the messing hha

It is possible but the ST exhaust must be modified to fit under the wheel well. To do this you have to cut the exhaust tips and weld them back on in a different angle to fit to the bumper. Because the ST exhaust must be mounted at a lower position to fit under the wheel well the exhaust can be seen from the rear which in my opinion does not look nice.

 

 

In my opinion it would be a lot easier and better looking to make a custom stainless steel dual exhaust system. 

+1

Like this:

Thanks for the replie lads think will just find a normal exhaust save all the messing hha

Cheap enough to get a dual exit bult mate around 80-150 pounds depending weather you choose standard or stainless, any exhaust business that has a manderail for bending pipes can do it

Ye tha looks nice Lenny will get a quote