Leaderboard

try here i use them all the time & quick postage www.buypartsby.com if ur not sure on the part then phone them with the reg of car & they will sort the parts for you i recall it was £25.00 each complet arm with bushes and ball joint thats inc vat about £57.00 for a pair inc postage if your going for a genuine ford part that will be £95.00 each side

8) gently pull the screen away from the board, take note that the screen is connected via pins on one side and not both. and place in a safe area. 9) you are now left with just the circuit board and all the SMD LED's are on show. unsolder and resolder how you see fit. i did however find that if the soldering iron is too hot the small pads on where you solder to, come off and a little repair work is needed. so turn your soldering down (i used position 1 of 2 on mine) if you dont have that luxury just keep switching yours on and off to keep it hot but not as hot as it can go...if that makes sense. the 28x 1206 SMD LED's are shown by a red arrow the 4x plcc-2 90 degree SMD LEDs are shown by a blue arrow EDIT: i have just noticed on review that 1x 1206 actually has a blue arrow and was meant to have a red. (bottom left corner) 10) once completed reassemble in reverse order and connect back up to your car. 11) once you turn it on, it may, ask you for a code. press the number 1 button to cycle to the right number for the first digit, number 2 for second digit and so on. press 5 to accept the code. 12) turn your lights on and enjoy!!!!