Hi all, I’ve recently purchased a 63 plate Zetec Ecoboost and have noticed this light (attached images) hanging down in the glove box. I’m assuming it’s supposed to somehow be attached to the ambient light strip above the glove box. Anyone any idea where to put it as can’t seem to see where it should fit in. Also is it possible to change the colour of this light?

I see it tomorrow and try to send pic if now one reply

 

Hi feel to the left underneath the dash where the light strip goes within and you’ll feel it. The end of the light strip locates in to the led recess in the module (shown above), then the module just clicks in to place in a little clip in that position. 

Trial and error it or try to position your eyes under to see what you have and it’ll make sense.

The led is red/orange only.

15 hours ago, Smartd00d said:

Hi feel to the left underneath the dash where the light strip goes within and you’ll feel it. The end of the light strip locates in to the led recess in the module (shown above), then the module just clicks in to place in a little clip in that position. 

Trial and error it or try to position your eyes under to see what you have and it’ll make sense.

The led is red/orange only.

Thanks so much for this! When I get a second later today I’ll have a play now I know what I’m looking for :) 

@Smartd00d very sunny out so not the best photo but all hooked up. Very easy to connect once I knew what I was looking for so thanks again for the explanation! 😀

No problem 👍