Johnyy

won’t start after cylinder head change, fault P0106 Manifold absolute pressure

Recommended Posts

Dear fellow Ford owners, 

Over the weekend I removed my cylinder head due to a burned gasket! I took everything out according to ford Manual, same back! When tried to start it once again, it refused to! It shows an engine malfunction! After reading with a scanner, the only fault I got was P0106 Manifold Absolute Pressure! I checked the air intake components for vacuum leak however everything was just fine! Could it be because of bad timing? If the timing would be not correct would there be a fault code? The car was starting before! Any help is very appreciated! Thanks!

 

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.