I was just wondering if you can fit the sensors onto the alarm that is already there,i think there are 2 on each pillar on the top,i can see the holes in the pillar but would there be wires there and if so what's the exact name for them.

Thanks

I think you are probably referring to the 'Ultrasonic Movement' sensors.

I don't think they will have put the wiring through for them and I can see it could be a  problem adding it.

Also it's not normal to fit more than one pair of ultrasonic senors (transmitter TX and receiver RX) as it would likely cause interference. I don't know for sure but possible they fitted one pair just on one door pillar and which side they were fitted on depended on LHD/RHD.

15 hours ago, unofix said:

I think you are probably referring to the 'Ultrasonic Movement' sensors.

I don't think they will have put the wiring through for them and I can see it could be a  problem adding it.

Also it's not normal to fit more than one pair of ultrasonic senors (transmitter TX and receiver RX) as it would likely cause interference. I don't know for sure but possible they fitted one pair just on one door pillar and which side they were fitted on depended on LHD/RHD.

I see,so this is why i just have the normal alarm on from the Factory when it was new,just i have always seen the place where it looks like they would fit and never seen any fitted.

Cheers.