MK3 2011 Central lock works only drivers door

5/2011 Ford focus 1,6 Diesel commonrail manual stw 5 doors

MK3 2011 Central lock works only drivers door

and the tailgate works too,
passenger door no, and neither rear door.
Won't lock or open.

does not work with the remote control, nor from the key slot or the button on the dashboard. Only the driver's door and tailgate work. locked and unlocked.

-The use is a bit difficult because you can't lock other doors than the one between the doors by turning the handle/hole to the lock.

-it all started when the bulb was replaced, the high beams stopped working. the fuse was broken.
new fuse and it still didn't work, the fault was found inside the BCM, the circuit board was burnt next to the micro relay,

it has been tinned and the lights are working again. But the central locking apparently stopped working at the same time.

-in the user manual, there was a function change when you press the open/close buttons for 5 seconds, the blinkers flash 2 times, and that function should go on/off, but it doesn't help, the blinkers flash 2 times, but the function doesn't change, the same continues.

-there is no module in the doors, I looked at the driver's door

-the central lock module is nowhere to be seen, according to the instructions it could be behind the glove compartment or in the left rear compartment next to the fuse box. There are also no fuses for the door modules even though the manual says so. the slots are empty.

-central locks fuse is 70,when you lock or open the driver's door, the relay clicks in the bcm box, if you remove fuse 70 it doesn't work either.

-does the bcm only control those door motors?? no control box?

-I can't find wiring diagrams for that 2011 model, where can I get one?

---if you have to change the used bcm, what do you have to code??

immobilizer? what else? Does it work forscan?

I saw that Delphi/autocom can save the original settings and you can copy from there when you have changed the bcm. I looked at Forscan and didn't see that it was possible to save the old one?

Thanks allready help me