Hi there,

recently my ACM burned and was not working. So I get a new ACM from marketplace everything works fine except the volume buttons. Both on the steering wheel and radio units. I tried to reprogram with Forscan, FoCCCus with no luck. 

So the Original ACM's part number is: 

CM5T-19C107-HD

New One's:

CM5T-19C107-KD

I dont know why the volume button is not working, what should I do? 

I also have the full sync2 kit and parts but don't want to do that right now.  This ACM also comes from that sync2 kit.

Any help is appreciated.

 

1 hour ago, Ugurcan Kesman said:

So the Original ACM's part number is: 

CM5T-19C107-HD

That's what you needed to replace it.

Using forscan, with paid license, plug the old ACM back into the car, read and download software/firmware levels using Forscan

Read and copy the ASbuilt config files from the old ACM and save to your PC

Install replacement ACM, install software/firmware from old ACM to new ACM, reset module

Install saved ASbuilt files from old ACM to new ACM

1 hour ago, Ugurcan Kesman said:

recently my ACM burned and was not working

That may not be possible.

1 minute ago, mjt said:

That may not be possible.

Providing it shows up when connected and he hasn't deleted the profile, it should all be there

10 hours ago, DaveT70 said:

That's what you needed to replace it.

Using forscan, with paid license, plug the old ACM back into the car, read and download software/firmware levels using Forscan

Read and copy the ASbuilt config files from the old ACM and save to your PC

Install replacement ACM, install software/firmware from old ACM to new ACM, reset module

Install saved ASbuilt files from old ACM to new ACM

Hi there,

I"m trying to do it like you said but there is no ACM section on the forscan config.


I only have theese sections and already tried to backup the apim configure from old acm and pasted in new acm still no luck.
Btw old acm just resetting himself when I try to open on thats why I said its burned.

And dont know if it helps but I found this from central configuration 

you need to source a CM5T-19C107-HD

On 8/17/2023 at 10:37 AM, DaveT70 said:

That's what you needed to replace it.

Using forscan, with paid license, plug the old ACM back into the car, read and download software/firmware levels using Forscan

Read and copy the ASbuilt config files from the old ACM and save to your PC

Install replacement ACM, install software/firmware from old ACM to new ACM, reset module

Install saved ASbuilt files from old ACM to new ACM

The ACM in European cars is not programmable. The only configuration you can change is in the central config on the BCM and the ACM picks up certain settings from there.

I gave up guys ordered an aftermarket android carplay on Amazon