ok so i bought a ford monedo 2.0l tdci off a friend as it died on him and he couldnt get it running again.

work he had done after it died

crank shaft sensor, cam shaft sensor, new ecu kit, fuel rail pressure checked and good all fuses checked all good.

i have checke dthe car over and everything says it should be running what am i missing as most parts to blame have been replaced has anyone got any suggestions ???

apparently he was driving home one day and it just cut out

 

Injectors??

 

apparently he checked the injectors they all work but he had someone test with a scope and there firing in a funny sequence which is why he got the new ecu kit as there supposed to self learn there codes

still wont start and no injector obd codes showing

only code that appears intermittently is map sensor

ok so i reprogrammed the injectors just incase still not starting so i went into some other diagnostic scan options on my autocom and got the following codes

e was more codes

These codes did not show on the standard diagnostic check

 

Thing is, those codes might be historic as there are no date stamps against them. Best to issue a 'clear errors'

and see which ones if any reoccur.

If the egr valve is partialy stuck open then the car wont start.has the egr valve been changed ?

egr removed and fully cleaned but back on car still same issue

tested the fuel pressure regulator on the pump that is working fine

new map sensor fitted so its ha a  map sensor maf sensor crank sensor

is there an electronic fuel shut off of any kind on this car ???

the egr error has gone infact all codes have gone except

 

p1000 obd cycle not completed

c1310 brake hydrolic pressure transducer front left wheel circuit failure

i dont see how these are relivant to the no start issue im having

i double checked the injector programming

 

wrecking my brain here trying to get this thing back running