Hi I have just had my ST spoiler painted and it is now ready to fit to my car, I know this is a straight swap as I have seen other posts on here in regards to doing it. 

The post I found said it has a guide on it but when I click the link it is just a dead link.

Does anyone still have the guide please?

I am also aware that when changing the spoiler it is advised to seal certain parts due to the known issue of water ingress into the roof lining / boot. I am unable to find a guide to this either?

The third brake light has two wires running to it and I am aware that the connector needs to be cut off to make it work on a non ST car. I did read that the positive wire should be thicker then the ground wire but both wires on the third brake light are the same thickness and colour?

I have attached some pictures...

 

Here is a guide https://www.jamessimpson.co.uk/how-to-fit-focus-st-spoiler/ some say to silicone around the bolts but I had no problem when I had done mines.

Do not forget to tell your insurance company you have fitted it.

5 minutes ago, eddie eastwood said:

Do not forget to tell your insurance company you have fitted it.

Thanks for the concern, it is already on my insurance along with the rest of the ST body kit 🙂 

When I took out my insurance I already had the parts and knew that I would be fitting them. Surprisingly my insurance would be a lot cheaper if I had an actual Focus ST!

6 hours ago, F0CUE said:

Here is a guide https://www.jamessimpson.co.uk/how-to-fit-focus-st-spoiler/ some say to silicone around the bolts but I had no problem when I had done mines.

Thank you, all fitted and working 🙂